Over Heat Protection Rotational Stainless Kettles
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1000 Units unit
- Supply Capability:
- 100,000 Units unit/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Over Heat Protection Rotational Stainless Kettles
Specification of Over Heat Protection Rotational Stainless Kettles :
Power: | 1000-1200W, 1850-2200W |
Voltage: | 110-130V.220-240V |
Frequency: | 50/60Hz |
Capacity: | 2.0 L |
Material: | Stainless Steel |
Tick Mark: | Inside Body Marked |
Features:
Heat automatic when the temperature low than 80ºC
Double layers of stainless steel body
Double thermostat, high-efficiency and energy saving
360 degree rotational base
Anti-dry and power off automatically
Fast boiling, only 5 minutes
Packing Details:
Units / Carton | 16 Units | QTY LOAD 20' | 3600 Units |
Carton Size | 69*35.5*54 cm | QTY LOAD 40' | 7280 Units |
N.W./G.W. | 12.5kg /13.5kg | QTY LOAD 40'HQ | 8480 Units |
Certification: CE /ROSH /LFGB
- Q:The electric kettle does not light the water. Is there a problem? Can I fix it? How do you fix it?
- Heating tubes are more likely to burn. This thing is broken, the pot is basically scrapped
- Q:The electric kettle temperature control switch is broken. How can I fix it?Can't fix it!
- After heating, the indicator light does not turn onThe fault is often caused by power supply without adding electric heating tube circuit. When overhaul resistance of R * 10 with a multimeter measuring gear base power line 3 core plug L and N ends. Normally, without pressing the reset switch when the resistance is infinite, press the button when the 1500W electric kettle corresponding resistance is 32 ohm. If you press the button for resistance with heating of the tube can be measured. This circuit not pot body 3 core plug N, L resistance, the normal value above. If measured normal results, show that the fault in the base part, should check the power line and the base socket connection is broken or poor contact, a simple structure in general, can quickly find the fault.If the measured resistance is infinite, the fault in the circuit inside the pot body, should open the handle cover components such as maintenance. Focus on the power supply (reset) switch and switch insulation. Multimeter R * 1 gear check switch action and contact on-off case is good. If it is found that the adverse action, the bending angle can be checked a temperature sensing piece of switch and the connecting rod position is normal, otherwise should carry on correction; if the switch action is normal and the contacts are not connected, indicating switch reed or contact damage, can open the switch box cleaning and maintenance.If the power switch is normal, then the fault occurred in the insulation switch. First look at the bimetal if the reed pressure switch contact rod (Bai Sugan), if the pressure is too tight, it can clamp the bent upward, until the distance between the 0.1mm so far. If the spacing of the bimetal sheet and switch contact rod should be normal. Open the switch box, cleaning and maintenance insulation switch springs and contacts.
- Q:What method can let the electric kettle on the outer layer of clean oil
- Stainless steel case, electric kettle, decontamination method:Apply a small amount of toothpaste in the dirt, then wipe it with clean cotton cloth, and then remove dirt;Electric kettle to cut off the power supply, with a piece of vinegar soaked cloth, on the outer surface repeated several times, and then rinse with water, careful burns;Electric kettle to cut off the power supply, in the appearance of dirt, cloth with a small amount of soda powder, wipe back and forth, dirt can be removed, careful burns;Plastic shell is recommended with detergent or neutral detergent, scrub without dilution, and then rinse with clean water.
- Q:The thermos kettle is plugged in for 24 hours for a long time. Is the heat preservation function very electric?
- I'm an electrician! Electricity can be calculated.It takes 10 minutes for heating in our house and 30 seconds for heating every 10 minutes. Then 1 days to 30*6*24=4320s=1.2 hours, see ~ ~ ~ heating 10 minutes of hot water, the daily heat preservation will be heated for 1.2 hours.How much electricity do you use?!
- Q:The electric kettle has been burning hot water for two hours. Can I use it?
- Heating wire did not burn on the good, you can continue to use, there should be overheating protection ah, automatic power failure ah. Note that this can easily cause electrical fires. Be sure to pay attention later.
- Q:Where can I buy an electric kettle under 500 watts?
- 500 watts? So low? We use 1500W or so!
- Q:The electric kettle suddenly stopped working
- Then remove the kettle's base.
- Q:Why does the electric kettle have the highest water limit?
- Injection of the liquid in the pot at least the heater should be higher than the highest surface a few millimeters, but can not exceed the highest level of the specified line; otherwise, easy to overflow water, use must be filled with water, after electricity, avoid to electricity, after installing water; do not use electric kettle to boil with acid, alkali and salt composition of things, in order to avoid corrosion of the kettle body and a heater; electric kettle when not in use, should be placed in a dry place, avoid moisture and reduce the safety performance of the electric kettle; it must be kept in the water heating process, and placed in the reach of children; the kettle from its socket before heating, to ensure that the power supply is disconnected.
- Q:Electric kettle boil a pot of water, about ten minutes or so, how much electricity will use?
- 3.1 power should not be used
- Q:I just bought a Japanese kettle. The voltage is one hundred volts. Could you use my power?
- Take a look at the plug or kettle body, the voltage is 110~220V, yes. And Japan, the voltage is 110VAdopt landlord, thank you! O (a _ U) O~
1. Manufacturer Overview |
|
---|---|
Location | cixi,China |
Year Established | 2010 |
Annual Output Value | Above US$16 Million |
Main Markets | Mid East;Western Europe;North America |
Company Certifications | ISO 9001:2008; |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | ningbo |
Export Percentage | 0.9 |
No.of Employees in Trade Department | 160 People |
Language Spoken: | English;Chinese;Japanese |
b)Factory Information | |
Factory Size: | Above 5,000 square meters |
No. of Production Lines | 4 |
Contract Manufacturing | OEM Service Offered;Design Service Offered |
Product Price Range | Average |
Send your message to us
Over Heat Protection Rotational Stainless Kettles
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1000 Units unit
- Supply Capability:
- 100,000 Units unit/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Hot Searches
Related keywords