Factory in Stock Automatic Tent 3-4 people Outdoor Windproof and Rainproof Entrance Tent

Add to Cart

Place Order

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Size: (about) 210 * 210 * 160 / 140CM

Package size: (about) 20 * 20 * 115CM

Weight: (about) 5.1kg

Water pressure resistance: 3000 mm

Fabric: 150D Oxford pu3000mm

Pole: semi aluminum automatic support

Accessories: handbag, fluorescent ground nail x 8, fluorescent wind rope x 6, front hall pole x2

Details：

Installation method：

Q: Is the inflatable bed available in the tent?: This design is reasonable: heavy truck pressure inflatable bed is not bad, load more than 272KG (more than double bed, single bed, 150KG) impact more than 5000 times, INTEX inflatable bed using a special honeycomb inflatable design, make two different weight to sleep on, will not be air to run phenomenon. This is the difference between a column inflatable and an ordinary long inflatable bed.This warm and comfortable: on the basis of "ergonomic design" principle, the use of air buoyancy to the human body to achieve uniform support, bed and human tightly, cervical and lumbar and leg wrist is no longer vacant, to eliminate fatigue, to create a natural, comfortable and healthy quality of sleep for you!

Q: A common problem with a pneumatic tent: Handling leakage point:Tools needed: air column fabric, special glue for manufacturer. If the leak point is a very small hole, can use a small piece of cloth (jattu gas column Zhuo any specifications of the inflatable tent there are standard), then brush the glue dry after dispensing, to be affixed to the leak, tight bonding. If the leakage of gas column joints for sealing plastic, can be divided into the following steps:First, clean the bonding surface first.Two, the inflatable tents will be given a bottle of glue, inflatable tent column special glue, brush it on the surface of the pre bonding surface, and must be painted evenly, the thickness is appropriate, brush two times, you can glue.Three, sticky interface shape must be designed as round or oval, as far as possible avoid square and sharp angle interface shape, lap width shall not be less than 30mm.Four. When the glue has been volatilized, it can be bonded. The patch shall be flat, free of wrinkles, rolled and scraped. At the same time, the hair dryer is supplied with heat source to facilitate bonding. 6 hours after bonding, it can be inflated. (Note: glue and air column can not fill the leak. The glue must be dried before it can be adhered. The time is about 10-20 minutes.)

Q: The camping tent to buy a big point, aluminum rod and glass rods which use resistance better? What quality brands do you have?: Selection of outdoor tent support: aluminum rod or glass fiber (glass fiber reinforced plastic)? Tent stand is one of the core components of tent, mainly used to prop up clothes. Usually the tent bracket length of each section is 25cm to 45cm, the diameter of 7mm to 12mm, with a hole in the middle, multi section pole by elastic rope connected between each set in a splicing method for connection, spliced into a long rod. Tent bracket is mainly divided into aluminum alloy rod and glass fiber pole two kinds of material, the tent stand on the market at present also mainly take these two kinds of material as the main.

Q: Which is better, tent, drawstring or spring?: Or choose the rope bar, the structure of the spring compared to a little more complicated, may be better than pulling rope tricky, personal point of view for reference only..

Q: The difference between a double deck tent and a double deck tent: Only a single tent tent with double layer, two outer layers, double insulation is just one aspect of the double deck waterproof on a great advantage, especially when the temperature difference between inside and outside the tent of the dew, this is very useful, can be separated in the middle of the outer and inner layers. However, the specific rainproof index should be determined according to the fabric and coating

Q: Can the tent protect the snake?: If you can hit the floor, branches, leaves or bamboo mat, try not to use the weeds. Before you go to bed, knock on the ground first and sweep away the insects that climb. When you wake up, you should look carefully around the body, otherwise, if there is a snake or insect nearby, it will be disturbed by the sudden activity.

Q: Classification of automatic tents: But from the price point of view, the only two hundred 5-8, but two hundred or three hundred people, this is light rain, thin cloth tear resistant ability is poor, the family is almost clear weather in recreational use, control of the children also need to prevent tearing damage. And in the middle of the grade in four hundred or five hundred or even thousands of caixing!When you play manual tents, you know so much about automatic tents! Refer to the genuine mobigarden manual double tents to 400 yuan, the highest price of the home, there are slightly more expensive and foreign Keller stone, more expensive than the manual and automatic tent! Should be more expensive

Q: How to install and use the cotton tent?: The last step is to hit the nail and the pull rope is the best camp, force, angle to good, that prop up the tent was strong and beautiful, live comfortable.

Q: Are there many tents at the top of Taishan?: There are a lot of people in tents, but not crowded, but I feel very busy and feel very good. Safety is no problem. There are many shops rent tents, coat, looks like nobody cares where you ride, as long as not too dangerous.

Q: What kind of support frames and fabrics are used in the tent?: Aluminum alloy skeleton: more high-grade, according to the alloy ratio test is also difficult, generally its original stent, overall radian curve, are calculated first, and then hot pressing shape processing. The utility model has the advantages of portability and convenience, but is not easy to fold, but the quality is poor, and the utility model is easy to bend and deform.Fabric waterproof fabric technical indicators shall be waterproofWater repellent is only painted with AC or PU. Generally used only for children or game accountsWaterproof 300MM is generally used for beach curtains / Sun curtains or for dry and wet cotton curtainsWaterproof 800MM-1200MM for conventional camping tentsWaterproof 1500MM-2000MM is used to compare mid-range tent, need to travel for many days.Waterproof 3000MM above is generally a professional tent, to take high temperature / cold resistant, cold and other techniques.Guangzhou tent bottom material: generally use PE is the most common, quality is good or bad depends mainly on its thickness and longitude and latitude density. Better, more high-grade fabrics in Oxford, waterproof treatment at least above 1500MM.The inside fabric is usually breathable nylon or breathable cotton fabric. Quality depends mainly on its density.

Send your message to us

*Email

*TEL

*Quantity

*Unit