Mobile Home Solar Panels - Polycrystalline Silicon 250W Solar Panels
- Loading Port:
- China main port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 100000 watt
- Supply Capability:
- 10000000 watt/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Specification
About us
CNBM International Corp, established in 2004, is the business entity for trade and logistic of CNBM Group.With the
advantages in Cement, Composite Materials, New Building Materials and Engineering, CNBM mainly concentrate on coal, steel
and construction equipments and give priority to solar and wind energy development.CNBM International is highly recognized
by its business partners and clients all over the world and has established good business relationship with the customers
in over 120 countries and regions all over the world.
Introduction
This installation Manual contains essential information for the electrical and mechanical installation that your must know before installing CUSTOMER PV modules. This also contains safety information you need to be familiar with .All the information described in this manual are the intellectual property of CNBM and based on the technologies and experiences that have been acquired and accumulated in the long history of CUSTOMER. This document does not constitute a warranty, expressed or implied.
Data sheet
Maximum Power | 250W |
Efficiency | 0.154 |
Backsheet | White |
Frame Colar | Silver |
Manufacture Site | China |
Frame | Anodized Aluminum Alloy |
Weight | 19 kg |
FAQ:
Q1: Why buy Materials & Equipment from OKorder.com?
A: All products offered byOKorder.com are carefully selected from China's most reliable manufacturing enterprises. Through its ISO certifications, OKorder.com adheres to the highest standards and a commitment to supply chain safety and customer satisfaction.
Q2: What is a solar PV module?
A: A solar PV module consists of many solar cells that are connected together (typically in series) and packaged in a frame (typically made of aluminum).
Q3: What are the advantages and disadvantages of monocrystalline solar PV modules?
A: Monocrystalline solar PV modules are the most efficient type of solar PV modules, with the exception of CdTe thin film solar PV modules. As a result, monocrystalline solar PV modules are more expensive when compared to almost all other types of solar PV modules.
- Q: Can I add more solar panel let say up to 200 watt and adding two 2 volts battery using the same charges controller and power inverter?
- You can wire solar panels in parallel (i.e. positive to positive, negative to negative). Preferably, the panels should be similar to allow the output voltages to track. Otherwise, it may be necessary to include diodes in series with each panel so voltage variations do not have an adverse effect. The other alternative is to have the panels charging individual batteries and then combining the batteries through diodes before using the inverter. This approach would require separate charge controllers for each battery. Not quite as energy efficient as each diode causes a voltage drop (and so a power loss).
- Q: What's the best deal going on companies leasing out Solar Panels in California?
- you have been very mislead by someone. Or ? did you listen to a Obama speech or something ? EDIT ; thanks for response via e mail. But if you think you can save money by, renting solar panels , then you are a very ignorant person. The only way that a scheme would would work ,is if the company that is leasing the panels to you ,,have bribed lobbied the local or fed politicians to get subsidized to provide the panels. then they get payed to install them and guaranteed to make a profit by the gov. for green energy that is why you have to pay 25 cents , while most people pay 0 cents , because you subsidizing all the profits of these Professional thieves. Who's job is to find new ways to get into that deep pool of public dollars,,tax dollars . Question for you .. Do really think the rented solar panels will? ) pay for installation 2) pay for the cost to buy the panes 3) pay the sales commission to the people that sold it to you 4) pay the on going commission to those that over see them 5) Add to that the higher rate on your elec bill to pay for these people to be subsidized , so they can rent you some solar panels ??????? Like I said ,,,,,,,you must be very ignorant about energy. Or very Ignorant about the thousands of companies that are formed to succk tit of the tax payers. You are ignorant on both of those points. So dont get piisssed of at me for answering your question !!!!! Instead , you should ask why you are so easily led ? Why you are so easily fooled by the users ? That is those that use the gov to use ignorant people like you. HAHAHAAH. And you fell for the whole scam without even realizing it That is why I use the word ignorant ,, because you are. If you dont know what ignorant means google it to find out. because you are,
- Q: I have an electric bicycle that I travel to work by, pulling a modified child carrying trailer that holds two 2 volt deep cycle batteries in series to power the 24 volt bike motor. I'm thinking about adding a 50 watt solar panel (or larger depending on the room I can make available) to charge while I'm at work and to provide some extra juice while on my more distant travels.Can I get a solar panel to charge them while they're connected the way they are: in series? Does charging work that way?I've read that in order to charge the 24 volt battery setup (if the answer to the Q above is yes), the output from my solar panel would need to be a little more than 24 volts. Is this true? If so, how many volts?Since the bike is supposed to be powered at 24 volts and I have an x-volt (x gt; 24v) solar panel connected to it, will this cause any damage to the controller or other components while running them?Will it help supply power even while the motor is being run?Thanks.
- Yes, you have it right you need two 2V panels wired in series to give 24V to charge a 24 volt system. But along with the 24V you also want some amperage, otherwise it takes forever to charge. Most of the little chargers are called trickle charges because they only have an amp or two. If you had two 25 watt solar panels putting out 24V you have : watts = volts * amps 50 watt = 24V * x amps x = 2 amps If your battery is say 50 amp hours of storage, then if you are putting in 2 amps it will take you 25 hours of sunlight to power it back up from a dead battery. So the charge time depends on how many amps you are putting in there at 24V A car battery charger typically charges at 0 amps at 2V, so 2 * 0 = 20 watts of power going in there So if you go solar make sure to use a charge controller and a big enough panel to get close to 00 watts for any decent recharge time. The charge controller makes sure that the battery only gets voltage going one way and it least 24V. So if the sun went behind some clouds and the voltage dropped to 20V, the controller shuts off the current until the voltage equals 24V or more
- Q: Can solar panels be used for powering an airport or transportation hub?
- Yes, solar panels can be used to power an airport or transportation hub. Many airports and transportation hubs around the world have already started using solar panels to generate renewable energy and reduce their carbon footprint. Solar panels can be installed on rooftops, parking lots, or in open areas surrounding the airport or hub to generate electricity. This clean and sustainable energy source can be used to power various operations, including lighting, heating, cooling, and even charging electric vehicles. Additionally, excess energy generated by solar panels can be stored in batteries for use during low sunlight periods or at night. Overall, solar panels are a viable and eco-friendly option for powering airports and transportation hubs.
- Q: Can solar panels be installed on metal roofs?
- Yes, solar panels can be installed on metal roofs. In fact, metal roofs are considered to be one of the best types of roofs for solar panel installation due to their durability, longevity, and ease of installation. The metal roof provides a stable and secure base for mounting the panels, ensuring optimal energy production. Additionally, the smooth surface of metal roofs allows for efficient panel placement, maximizing sunlight absorption.
- Q: We are looking in to buy solar panels for our house. The payment has to be around or under $4000. Our house is a 4 bedroom and 3 bath 2-story house. (Around 2500 sq. ft.) Where can we get the solar panels? Also: Will it heat our water? When we get the solar panels, what direction do they have to be facing?
- yahoo store online
- Q: Got a small project here in a remote location. There is to be a 2 volt deep cycle battery, the equipment to be powered from battery and solar panel to charge battery. The 2 volt battery puts out 55 AH. the max constant power draw from the equipment to be powered is 7.9 watts. Will a 30 watt panel at 2 volts be enough to run this system during sunlight and charge the battery for the equipment to run overnight?And, at 55 AH, how long can I keep a constant draw of 7.9 watts without a recharge?Thanks to all the input!
- Create okorder /
- Q: So you know how the bigger the surface area exposed to the heat radiation means the quicker it'll heat up.Is this what happens with solar panels, they have a large surface area exposing to the sun, so they can get more heat?
- Solar panels do heat up. But that's because the radiant energy from the Sun that lies within the infrared (IR) band of energy causes the material in the panels to heat up. And that's the same for any body that has the Sun shine on it. Your face, for example, will heat up while you get a nice tan on the beach. That's due to the heat producing IR radiant energy. Now if those solar panels are supposed to heat buildings etc., that heat produced in the panels when the IR strikes them will be transferred, usually by some fluid, to floors of the rooms to be heated. And as the amount of heat generated by the Sun is proportional to the area of the solar panels, bigger areas of panel will generate more heat than smaller areas. Photoelectric solar panels are another kind. Here the interest is in the visible band of radiant energy from the Sun. Heat, from IR, is still there, but it is not the product sought by PE solar panels. The visible light photons knock off loosely bound electrons from the photoelectric material (typically silicon based) and those electrons are siphoned off as current. That's where the electrical power comes from for buildings using PE solar panels to provide their own electricity.
- Q: I am doing a project for school and i need to power a 9v DC motor using a solar panel. Does anyone know places i could get these for not to expensive, and how many volts/watts i would need?
- Jameco okorder /
- Q: What is a good sight that I could go to about installing solar panels and all of the considerations of it?
- That okorder /... In both cases I would recommend you call to get specifics before ordering anything.
Send your message to us
Mobile Home Solar Panels - Polycrystalline Silicon 250W Solar Panels
- Loading Port:
- China main port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 100000 watt
- Supply Capability:
- 10000000 watt/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords