LED Curtain Outdoor CMAX-CO-8.9

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

FEATURES

CO Series	CO-8.9
LED Configuration	SMD3535-N/SMD3535-H
Pixel Density	12544/㎡
Unit Size(mm)	500(W)x1000(H)
Unit Weight	13Kg
Unit Resolution	56x112
Module Size(mm)	250(W)x125(H)
Module Resolution	28x14
Scan Mode	1/4
Brightness(cd/sqm)	≥3200/≥5500
Driver IC	MBI5024/MBI5041/MY9269
Refresh Frequency	≥800Hz/≥1200Hz/≥2000Hz
Power Consumption(max/avg)(W/pc)	250/85
Gray Scale	≥12bit/≥14bit/≥16bit
Transparency	15%
View Angle	H140°/V90°
Curved Angle	±30°/no curved
IP Level(front/rear)	IP65/IP54
control system	NOVA/DBSTAR/LINSN
Working Temperature	-30°C - +50°C
Operating Humidity	10-90% RH

LED Curtain Outdoor CMAX-CO-8.9

Q: Ask to tell, or what decoder, mkv format can only put one, the rest of the mkv can not put any meaning?: a graphic editing, zoom, scroll, animation and other functions can display a variety of computer information, graphics, images and Two, three-dimensional computer animation, can be superimposed text ? broadcast system with multimedia software, you can flexibly enter and broadcast a variety of information ? a variety of Chinese fonts and fonts to choose from, but also enter the English, Spanish, French , German, Greek, Russian, Japanese and other languages ? There are a variety of ways to broadcast,

Q: 16: 9LED What is the approximate size of the display?: 16: 9 is only a proportional form, the specific size to be determined according to the area of the display. You display 16 meters long, 9 meters high, is 16: 9 ratio; display length of 10 meters, 5.6 meters high, is also the ratio of 16: 9. So there is no specific size!

Q: LED display how to install it?: This installation and cantilever installation similar, the same application, the screen body with a cabinet design, suitable for indoor, semi-outdoor screen body.

Q: LED display power supply how to configure how many units with the plate is calculated.: According to the unit board power calculation, P10 monochrome in general 10 to 12 blocks, indoor monochrome 12, indoor color 6, full color, then ask the unit board manufacturers, a board of how much power. And then calculate their own bar.

Q: LED display a board dark light how is it?: With a multimeter to measure whether the normal voltage of the unit board, and then measure the power module voltage output is normal, if not, then determine the power module bad.

Q: LED display more than the size of the area must be 380v: I installed the general are 380 to have some small screen with 220 plugs

Q: LED display applications are what: The development of modern information display technology, the formation of the CRT, LCD, PDP, LED, EL, DLP series of information display products, look at all kinds of display products, each have their own strengths and appropriate Market application requirements. With the LED material technology and technology to enhance the LED display to highlight the advantages of a flat panel display one of the mainstream products, and in many areas of social economy has been widely used,

Q: Led display brightness is not enough because of what are the reasons: If the screen is a very small piece of time is sometimes very dark, the unit is usually a problem, or drive IC problems, to replace. If the entire LED screen has become very dark, if the circuit board control system problems, it is recommended to restore the factory mode. If it is caused by the graphics driver, it is recommended to update or reinstall the driver.

Q: IPS screen and LED screen difference: LED is the backlight, longer life, lower cost, with TN screen you slightly higher performance, LED performance is good, high dynamic contrast. The disadvantage is too bright, a little hurt eyes. Now the mainstream are used LED screen, short response time, suitable for playing games.

Q: Led display speed how to tune: All need to display the data are ready, the "send" button to send data, select the need to send the frame and set the starting address, the point can be sent

Send your message to us

*Email

*TEL

*Quantity

*Unit