LED buzzer sensor,Manufacturer Of parking sensor -LED display ,4sensors，6sensors,8sensors,12V for cars

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

Testing

Connect the power wire of the control box correctly.
Connect the monitor with the control box. Put the shift lever to reverse gear to start the system up, and the monitor will send a sound of warning. For LED or LCD series, the displays show “--” or “.” At the same time. It indicates the system is under detecting status.
After the installation of sensors, adjust the direction to the correct, then arrange the wires in good order. Connect one sensor with corresponding outlet in the control box. It can operate normally if person stands in 1.0M. Check each of the sensors separately according to this way. Then connect all of them with the control box.
Enter into the back gear to make the system working. Lay a obstacle behind the car, and change the distance and orientation to test the system. If the system with 6-8 sensors is installed, switch off the power after finishing the test of reverse detection, move the obstacle to the front of the car, then apply the brake to test the front detection.

Q: Reversing radar and reversing images which expensive: Do you think the radar is more expensive or the camera is more expensive?

Q: Reversing radar to buy a car after their own equipment?: Yes, including reversing images, can be done through the late

Q: Reversing radar how to see: The newly upgraded parking assist system can be achieved during vertical and parallel parking, parking assist system can take over the driver's steering operation; if necessary, can also rely on a number of forward or backward to complete the parking.

Q: Reversing radar did not respond to what is the problem: Is due to the associated connection line connection caused by abnormal.

Q: Can the car reversing the radar in front of it?: Pre-installed insurance is usually called the parking radar. Install their own power adapter line alone in the cab to install a power switch on it, you need to close near the front of the low barriers, open the switch can be measured, and some still in front of the camera, and the rear is the same as the camera , Is also the same effect.

Q: The difference between a parking radar and a reversing radar: The reversing radar is only open when the reverse gear is loaded. The parking lot is generally 40 meters below the continuous opening, there is a main switch can be closed

Send your message to us

*Email

*TEL

*Quantity

*Unit