Forklift Solid Tyre-

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

18*7-8

solid forklift tire
Special rubber compound for excellent cut resistance
Strong deformation resistance

Features:

1) Special designed tread pattern maximizes traction

2) Unique rubber compound extends tread wear and prevents chucking

3) Super strong tire construction provides exceptional load capacity

Q:How many kilometers can a car tire run normally?: Ten thousand km gear wheel, not change, if it is symmetrical pattern, then left front wheel, right rear wheel, rn right front wheel, left rear wheel, so cross change. Another 5000 kilometers, it is best to give the tire a dynamic balance.

Q:How to distinguish the quality of automobile tires?: Look at the tire code, this car owner may not pay special attention to it. Mainly to see whether the pattern and logo consistent, and there is the tire side whether there is a combination of traces.

Q:Do I need a dynamic balance check for the big truck tires?: Large truck tires need to be checked for dynamic balancing.

Q:What happens when a truck tire is not round?: The tyre lost round while driving there will be strong sense of shock, if it will affect the sensitivity of front wheel steering, steering wheel and seat has a very obvious shock, if it is due to the deformation caused by the wheel, there will be a tire air tightness is not strict, the phenomenon of gas leakage loss.

Q:Truck tread pattern and fuel consumption, grip: The above tires are suitable for medium high speed, better roads and ordinary roads with low noise. Mid tire is suitable for medium and low speed, ordinary road surface and noise. The following figure is used for engineering patterns, suitable for ordinary roads and conditions are not very good road surface, noise. Fuel consumption has a lot to do with the load and the road, as well as the driver's fuel consumption and speed, and the difference between the tread pattern is very weak. Abrasion resistance is closely related to quality.

Q:How are the tires classified?: Tread patterns can be divided into ordinary pattern tires, cross-country tread tires, mixed tread tires:Ordinary pattern of fine and shallow, suitable for relatively good hard pavement.The utility model has the advantages of deep and deep concave, good adhesion with the ground on the soft road, good off-road capability, and is applicable to the ground conditions such as mines, construction sites, etc..The mixing pattern is between the common pattern and the cross-country pattern. The middle part is diamond shaped, zigzag or pipe shaped. The two sides are horizontal cross-country, which is suitable for the road running between the city and the country.

Q:What's the depth of the new tyre pattern?: Car new tires in general 8-10mm, trucks are generally 17-20mm, and some deep patterns, some shallow, tire manufacturers are different, the depth of the pattern will vary somewhat,The tread depth shall be checked according to the following standard:Good: greater than 3.5mmSuggest changing next time: 2.5~3.5mmNeeds to be replaced: less than 2.5mmReplacement limit: 1.6mm

Q:What minimum tread depth is required by law?: For example, the deeper the tread pattern, the greater the amount of elastic deformation of the pattern block, and the rolling resistance formed by the elastic hysteresis loss of the tire will also increase. That is to say when the tire contact with the ground, will consume part of the force to offset the elastic deformation caused by the tire tread too deep, will form a larger drag on the car, affect the power input and increase fuel consumption. And the deep tread pattern is not conducive to the tire heat, in the running process of the automobile, severe tire and ground friction will cause the tire temperature rises up, tearing off phenomenon, the root pattern due to force serious and easy to cause the tire.

Q:How many kilometers does the car tire change?: But in the process of use, the following five situations need to be replaced:1, tire wear to wear limit mark must be stopped using (ie tread tread depth is less than 1.6 mm).2, tire aging. (for example, tread, groove, or tread, there are countless small cracks), you'll need to change the tire in time, whether it's a new or an old one3, tread deformation or bead damage of the tire, lack of gas, causing the tire side of the tire was crushed, corrosion by chemical tires may not continue to use.4, drum wrapped tires shall not continue to use.5, other damage, if the use of tire safety, may not continue to use.

Q:The car's got a flat tire. Can you run?: Hello, the tire is not gas, not recommended in the drive, and if continue to run, increased risk, and the tire side wall is to wear, resulting in tire scrap, it is recommended to replace the spare tire or rescue, and if in doubt, please ask! If you have any help, please accept and praise. Thank you!

3. Manufacturer Capability
a)Trade Capacity
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range