Q:Difference between Artificial Digging Pile and Bored Pile

reliable construction quality, construction in short time, shortening construction time and low cost The So it is widely used. Artificial digging pile is suitable for soil with better soil, lower groundwater level clay, sub-clay, with a small amount of sand and gravel clay layer.

Q:What is the difference between the instructions of the PCB drilling machine and the instructions of the CNC?

The instructions are one of the old documents, which is the instructions of the superior to the subordinate petition.

Q:Which CNC CNC drilling machine brand is CNC84 system?

PCB drilling machine is used in the PCB processing process of drilling a machine, PCB board in the assembly of components must be drilled holes in the board so that the components can be inserted into the pin, or make different levels of the line up and down conduction

Q:What types of PCB drilling machines and operating systems?

Products through continuous improvement and improvement, its performance fully meet the level of foreign brands, in a leading position in the country.

Q:Control Guide for pcb CNC Drilling Machine

Will pin fixed in the folder, multi-layer products should pay attention not to put anti-film.

Q:How can a vertical CNC drilling machine hit two horizontal holes, and two vertical holes? Why me

If it is a two-hole vertical hole, it can be done on the fourth axis.

Q:What is the working principle of automatic drilling machine?

CCD camera can automatically identify the missing holes on the material, can also be identified due to print or reflective or a variety of colors of the material!

Q:What kind of mechanical equipment is used for bored piles?

Impact drilling, punching drilling and rotary drilling into holes, etc. can be used mud wall construction method.

Q:What is the drilling machine hole

The head of the drill bit is sharp, in the actual drilling process, because the drill bit has just begun to be affected by the workpiece force is very large, prone to offset, resulting in drilling hole error is large, less than the design requirements tolerance range requirements.

Q:What is drilling? What is the characteristics of drilling?

The initial position of the hole is called the orifice, the side is called the hole wall, and the bottom is called the bottom of the hole.