Q:What is a pneumatic major?

If it is understood from the actual work situation, that is, pneumatic equipment related to compressed gas dynamics. Pneumatic connections, pneumatic control elements, pneumatic actuators, gas powered equipment, pneumatic tools, etc..Compared with electrical equipment, the use of compressed air drive, power supply cost is low, the action is soft, not overload, easy operation and maintenance; especially in places where explosion-proof requirements are more applicable.

Q:What does pneumatic component mean?

. The first step in learning pneumatic is to understand the pneumatic schematic diagram first. Schematic diagram is clear, and then combined with the actual understanding of pneumatic components, features.

Q:What does the pneumatic component contain?I'm a beginner. What pneumatic parts do I have?

If pneumatic components are to be designed, some knowledge of fluid mechanics and aerodynamics must be understood. The design of gas paths and pneumatic components is not just a hole, but the flow of gas can be as simple as it used to be

Q:Will the gas in the gas path corrode the pneumatic components after passing through the oil sprayer?

You may be confused with the filter because the filter is to filter the air source, such as air compressor output of high-pressure gas containing moisture, or particles, iron and other magazines. Get clean origins.Of course, if your origin requirement is dust-free, oil-free, without lubrication, then only filters are needed and no oil mist eliminator is required.

Q:Pneumatic components can be divided into several categories?

Use the attached elements together auxiliary element and a driving element, such as vacuum components, such as connectors, hose, muffler, speed controller, check valve, pressure gauge, manifold.

Q:Introduction of SMC pneumatic components

SMC pneumatic components over 11000 basic series, more than 610000 different specifications,

Q:Can nitrogen be used as the source of air for pneumatic valves? Generally use compressed air as pneumatic components of the gas source, suddenly asked customers can use nitrogen

Nitrogen can, of course, be more than 70 of the nitrogen in the air. Nitrogen is generally compressed air.

Q:Main points of type selection of pneumatic control valve

For pneumatic pipes, a little leakage is allowed, and the leakage of the hydraulic pipe will cause pressure drop and pollution to the environment.(three) the requirement of lubrication is differentHydraulic system of the working medium for hydraulic oil, hydraulic valve does not exist on the lubrication requirements; pneumatic system of the medium of work for the air, the air is no lubrication; therefore, many pneumatic valves need oil mist lubrication. The valve parts shall be made of materials which are not subject to water corrosion or take necessary rust preventive measures.(four) the pressure range is differentThe working range of the pneumatic valve is lower than that of the hydraulic valve. Pneumatic valve working pressure is usually less than 10bar, a few can reach less than 40bar. But the hydraulic valve has high working pressure (usually less than 50Mpa). If the pneumatic valve is used under the maximum allowable pressure. Accidents often happen.(five) the use of different characteristics;General pneumatic valve than hydraulic valve structure compact, light weight, easy to integrated installation, valve work frequency, long service life. Pneumatic valve is in the direction of low power and miniaturization. Low power solenoid valve with 0.5W power has appeared. With computer and PLC programmable controller connected directly, can also be installed on a printed circuit board with electronic devices connected through standard gas electric circuit board, save a lot of wiring, suitable for pneumatic manufacturing assembly line of industrial manipulator, complex etc..

Q:What are the special advantages of the pneumatic device of a vibrating screen?

4 、 high reliability and long service life. Electrical components of the effective action of about a million times, while the general electromagnetic valve life of more than 30 million times, and some good quality valve more than 200 million times.

Q:What elements are most common in pneumatic?

The most common should belong to the jointOur company specializes in the production of high-end white connector, CNC lathe