Wide Leg Electric Stacker 1.4T

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Model		CDD14	CDD16	CDD16	CDD12	CDD12	CDD14	CDD16	CDD16
Configuration No.		930	D930	950	030	970	920	D920	960
Power type		Electric
Operator type		Rider/ Walkie
Load capacity	kg	See load strain diagram and mast configuration table
Load centre	mm	600
Wheel base	mm	1325		1375	1270	1179	1325		1375
Standard mast lifting height	mm	3000		3700	3000	2500	3000		3700
Overall width	mm	850		937	812	1015	850		957
Ground clearance +fork thickness	mm	85				80	55	55	55
Service weight( with battery )	kg	1270	1329	1612	1135	1830/1890	1280	1330	1606

Q: Diesel forklifts generally take a long time to replace the oil: For the first time in the period suggested 50 hours to do the first oil change And with better oil level is above the CD, if you use the bad environment, see the purity of the oil, without a viscous dark or replaced. After the mill period, change every 200 hours. Basically 200 hours, the best method is to look at oil

Q: Which is better, solid forklift tyres and inflatable forklift tyres?: A forklift truck is a solid tire or pneumatic tyre? The characteristics of the solid tire of the forklift truck: good wear resistance and a life span of 3-4 Double, no rupture (unless the tyre quality problem)

Q: Notice those items before the forklift: Check the vehicle Before (1) forklifts, the appearance should be inspected, and the fuel, lubricating oil and cooling water should be added. (2) check start-up, operation and braking performance. (3) check the lighting and sound signal to be fully effective.

Q: Do forklifts need to be measured?: Forklift does not need to be measured because forklift is not a measuring device but is a special equipment. The forklift needs to be tested annually. According to the factory motor vehicle supervision and inspection procedures "China quality inspection boiler no. 16 [2002], article 3: the new and repair or reconstruction of motor vehicles in the plant, put into use before, shall, in accordance with the provisions of this regulation, a regular inspection every year. Encounter may affect the safety and technical performance of natural disasters or motor vehicles inside the plant after the equipment accidents, and stop using more than one year use of motor vehicles in the factory, again after a make-over, shall, in accordance with the provisions of this regulation the acceptance inspection of the content.

Q: Does the forklift have only one wheel? Front engine: They say there is nothing wrong, if you can walk in a day can only two feet from the distance, so your life can only walk on a straight line, this is the principle of differential, there must be slow to shift! The tire case about who knows how to skate! And you don't have the right place to work. Top wave back! It is. Or a forklift truck

Q: Is the stack a forklift truck: The stacker is not a forklift. Forklift truck is an industrial transport vehicle, which is a variety of wheeled transport vehicles for loading and unloading, stacking and short-range transportation. International standardization organization ISO/TC110 is called an industrial vehicle. Often used for the transportation of large items in storage, usually with a fuel engine or battery.

Q: The basics of driving a forklift: Note the position of the gearshift and the reverse pole. The speed of the forklift truck is slow, usually only one and two blocks, and a reverse gear is specially set up. When driving, first hang in the reverse gear, switch the forklift to move forward or back, then push the shift lever to 1 stop and start smoothly. The forklift does not stop changing direction, causing damage to the transmission.

Q: Special equipment, the type of vehicle for forklift licence and corresponding driving vehicle: The N2 forklift card can drive a forklift: 1, there is no limit to the type of driving car, and the tonnage can be opened. 2, short for "motor vehicle driving license", and "driving licence", in accordance with the law personnel required for motor vehicle driving licenses, previously known as forklift driver, now change to code, forklift driver code is N2. 3. The forklift driving is special operations, issued by the state production safety supervision and administration of the People's Republic of China special operations card ", forklift, generally are tools, only used in the unit within the work place. So generally speaking, you only need a position certificate or a license, but the average unit will ask for a driver's license.

Q: The photo of the forklift card is a few inches. Is it colorful?: I am a forklift driver training, as long as one inch of color picture is ok, the free crown, do not need blue bottom.

Q: What type of work is the forklift worker in the new labor law: You should look at you with the original state-owned enterprises to sign labor contract, time to what time, if the contract did not end, unit of choose and employ persons cannot be unilaterally change.

Send your message to us

*Email

*TEL

*Quantity

*Unit