The nut coke of size 20-40mm hot sale
- Ref Price:
-
- Loading Port:
- Tianjin
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1000 m.t.
- Supply Capability:
- 100000000000 m.t./month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
The physical properties of the coke with room temperature mechanical properties and thermal strength and chemical properties are closely related.Coke's main physical properties are as follows:
The average heat capacity is 0.808 kj/(KGK) (100 ℃), 1.465 kj/(KGK) (1000 ℃)
Thermal conductivity is 2.64 kj/(MHK) (room temperature), 6.91 kj/(MHK) (900 ℃);
Ignition temperature (air) is 450-650 ℃;
Low calorific value of dry ash-free basis for 30-32 kj/g;
We can offer below grade the NUT coke of 20 to 40 mm：
Quality | Quality guaranteed | Rejection limits |
Moisture (As receive basis) | 7% max | --- |
Ash (dry basis) | 12.5% max | >13.5% |
Volatile Matter (dry basis) | 1.5% max | >1.8% |
Sulphur (dry basis) | 0.65% max | >0.75% |
Phosphorus (dry basis) | 0.035%max | >0.045% |
Size 20—40mm | 90%min | |
-20mm | 5%max | >8% |
+40 | 5%max | >8% |
Coke physical properties including coke sieve grouped into truth, coke, coke powder density depending on the relative density of density, coke, coke porosity, thermal conductivity for the heat capacity of coke, coke, coke, coke ignition temperature, coke thermal expansion coefficient of thermal stress and coke, coke shrinkage rate, coke resistivity permeability, etc.
- Q: What is the density of coke?
- There is also a parameter is also available for your reference: coke porosity of 35% ~ 55%The above parameter is a general range, according to the need to choose to determine.
- Q: Coke is how to produce, what is its purpose?
- Natural coke. Coke can be obtained by high-temperature carbonization of coal:
- Q: Used in a restaurant?Dry or dry carbon carbon, coke or coke, and I do not know which word is a word of this sound. The use of coke for iron making. They are more than 1000 yuan price.The main problem is: dry carbon is coke?Toxic smoke, then the chimney can not do? Can I use the blower?
- Metallurgical coke is coke, coke, iron alloy coke and non-ferrous metal smelting coke ". Since more than 90% of metallurgical coke is used for blast furnace ironmaking, it is often referred to as coke.
- Q: What are the main uses of coke
- Main use of coke:1, is the most important coking products, more than 90% countries most coke used in blast furnace, blast furnace with coke instead of charcoal, laid the foundation for the large-scale modern blast, is an important milepost in the history of metallurgy.
- Q: Who knows the proportion of pig iron and coke used in Cupola
- Raw material inputs: the main raw material for casting pig iron, scrap steel, manganese, etc.. Under normal circumstances after the melting of ordinary cast iron scrap iron and scrap steel ratio of 9:1 or so, the drying enterprises use pig iron and scrap ratio of about 6:4, according to the requirements of the product. Because pig iron and scrap carbon content is not the same, the higher the carbon content of pig iron is about 4 ~ 4.3, low carbon steel scrap, about 0.8.
- Q: I see that there are metallurgical coke and coke on the Internet, what is the difference between them (I hope to be able to say in detail) and a level of two points, how is this going on?.. Where is the quality of coke in China? Hunan good coke plant which? Although the problem is a little bit more, I hope that insiders can give some useful information. Extremely grateful.
- Coke is a special and molten iron cupola coke. Coke is the main fuel cupola molten iron. Its role is to melt the burden and make the hot metal overheating, the support column to maintain good ventilation. Therefore, the foundry coke should have large blocks, low reactivity, porosity is small, with impact crushing strength, low ash and sulfur enough
- Q: Do not understand why some of the indicators of coke is the cause of the full analysis of phosphorus or foundry use of this time?It is best to use the foundry requirements? Thank you
- Phosphorus increased the brittleness of cast iron, the use of metal damage. Therefore, the requirements of the foundry phosphorus is the lower the better. Because of the large cupola furnace in the furnace is acidic, can not effectively dephosphorization, so the foundry coke in the phosphorus requirements as low as possible, and require the supplier to provide a quality guarantee form.
- Q: The cost of iron ore and coke
- Per ton of iron ore 490 yuan / ton, the use of steel per ton coke of 500 kg, coke per ton of 1250 yuan / ton. You can calculate the proportion of these data
- Q: The coke is divided into several separate uses
- Gasification coke is used for the production of coke gas. The utility model is mainly used in a fixed bed coal gas producer with solid slag discharging, and is used as a gasification raw material to produce CO and H2 as combustible components. The main reaction of gasification process:C+O2 - CO2+408177KJ
- Q: Mechanism of carbon and coke is not the same as the price which high?
- Now, carbon factory has been discontinued, I start the original work - cable maintenance. The first floor of the post is my hair, said all no empty words. A combination of equipment quality is too bad, and Beijing Shougang, cleaning the equipment of large and the fact they are and exactly the same. Beijing is a liar equipment. Zhang Lian do is a donkey trading, factory equipment do Ba Chau are defective, they sold to Beijing fake technology company. I was at his factory inspection equipment of Shougang crooks in the factory. They stay trapped the loss of numerous investors. I now have been unable to recover
Send your message to us
The nut coke of size 20-40mm hot sale
- Ref Price:
-
- Loading Port:
- Tianjin
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1000 m.t.
- Supply Capability:
- 100000000000 m.t./month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
