Rechargeable Mini Dehumidifier

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

FAQ

Q 1.Okorder Quality Control?
We hold a very strict quality control system to check every connector of our products for

your safety.

Q 2: How do you care for your kitchen appliances?
A: Keep good Ventilation indoor. Open the doors of the kitchen appliances, if not. There

will be some mildew on cutting board and other kitchenware, because the water vapor can not

evaporate easily.
Keep clean of all the appliances. Each kitchen has its special cleaning fluid，please go to

Kitchen cleaning stores buy some clean them on time.

Q 3: Which one do you use the most of kitchen appliances?
A: Assuming you mean small appliances .I say too many! At one time we would buy every one

that came along; including a hot dog machine, pizza maker, elec. carving knife, elec.,

toaster oven,. Most have been garaged sale (sold) or are stored in the garage. Most used;

coffee maker, microwave, blender and mini food processor. OK?

Q: What's the difference between freeze dryer, micro heat regeneration dryer, non thermal regeneration dryer and waste heat regeneration dryer?: Micro heat regeneration dryer - also called tepefaction regeneration dryer, 2 adsorption tower, every 2 hours to switch to a AB tower, A tower rotation adsorption, adsorption and regeneration tower B 2 hours 2 hours, whereas the B A adsorption tower adsorption tower regeneration is the water suction down air drying, but because of the adsorption so long as the regeneration to be heated to completely clean, renewable water is adsorbed to the water tower with its own air after heating

Q: What is the principle of a spray dehumidifier?: When the temperature of the wet gas drops below the dew point, the steam condenses and reduces the humidity of the gas

Q: What is the working principle of the dryer?: The heat from the heat source in a variety of ways to wet materials, the material surface moisture vaporization and escape into outer space, thus the moisture content difference in the material surface and internal. Internal moisture diffusion and evaporation to the surface, so that the moisture content of the material continues to decline, and gradually complete the drying of the whole material

Q: What are the remarkable characteristics of CMD membrane dryer?: Unique spiral winding technology to minimize volume and efficiency

Q: What are the characteristics of a radiation dryer?: The electric heating radiation dryer uses infrared light bulb to irradiate the drying material, so that the material temperature rises and dry

Q: What are the characteristics of a convection dryer?: The quality of water vaporization units with energy conduction type dryer high end products, especially when moisture content is low

Q: What are the factors affecting the dryer?: In the air around the particles, the absorption of heat and the diffusion of water molecules to the surface of the particles take a certain amount of time. Therefore, the resin supplier shall specify the time required for the effective drying of a material at the proper temperature and dew point.

Q: How to install the car air dryer?: Installation location: away from the heat radiation source, well ventilated, close to the gas road system, the first use of gas tank, drying tank top should leave 30 ~ 50mm space, in order to replace desiccant

Q: How do I choose the dryer?: Operating performance and economic index of dryer

Q: What are the clogging problems in dryer?: Refrigerant can not cycle, low pressure for negative pressure, air conditioning is not refrigeration.

Send your message to us

*Email

*TEL

*Quantity

*Unit