pv interconnect ribbon ribbon family
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- 339 ton kg/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
1、基材参数Base Copper Parameter
铜基材Base Material | TU1 oxygen-free C10200 |
成分含量 Content | CU>99.97% |
导电率 Electrical conductivity | ≥100% IACS |
电阻系数Resistivity | ≤0.017241Ωmm2/m |
2、涂层成分Soldercomposition
涂层成分 Solder Type | 涂层成分比例 Solder composition rate | 单面涂层厚度(mm) Solder Single Thickness(mm) | 涂层厚度公差(mm) Solder Thickness Tolerance(mm) |
含铅 (Leaded) | Sn60%Pb40% | 0.01-0.04 | ±0.005 |
Sn63%Pb37% | 0.01-0.04 | ±0.005 | |
Sn62%Pb36%Ag2% | 0.01-0.04 | ±0.005 | |
无铅(Lead-free) | Sn97%Ag3% | 0.01-0.04 | ±0.005 |
其他成分比例可根据客户工艺要求定制Other solder composition available according to customer’s technical requirement |
3、产品几何尺寸及公差Physical Dimension and Tolerance
类别 Type | 厚度范围及公差(mm) Thickness Range and Tolerance(mm) | 宽度范围及公差(mm) Width Range and Tolerance(mm) | 长度及公差(mm) Length Range and Tolerance(mm) |
互联条 Interconnect ribbon | 0.15-0.3 ±0.01 | 1-2.5 ±0.05 | 28-500 ±1 |
汇流条 Bus Bar | 0.2-0.4 ±0.01 | 3-8 ±0.05 | 28-1205 ±1 |
其他尺寸可根据客户工艺要求 Other Dimension available according to customer’s technical requirement |
4、Have the best match with cells andwelding machine.Deduct to the broken for cells.
5、Also increases solderability andconductive,this also results in maximum output efficiecy from module。
- Q: There are two years of foreign trade experience of the business to enter the basic salary and commission is what level is reasonable?Products are solar lights, solar chargers, solar power systems, solar power, LED induction lamps and other solar energy products
- Base salary is not high, the Commission is generally 1-2%, different places.
- Q: How to choose a good use of solar energy
- See building structureMulti story building: installation is not limited, vacuum tube solar energy and flat panel solar energy products can be selected. Senior and small high-level: balcony solar energy products can choose. Villa Construction: can choose to install flexible, can be integrated with the construction of flat panel solar energy, flat panel solar energy is not affected by high-rise and special buildings, beautiful and generous.See pipeBecause the water heater is often placed on the roof, there is a certain pressure and the house in the summer, hot water with high temperature (about 90 DEG C), the actual situation of low ambient temperature, so the best selection of crosslinking tube or plastic composite pipe or reinforced plastic hose. The utility model has the advantages of high pressure resistance, high temperature resistance, low temperature resistance, no toxicity, no odor, small heat capacity, small heat loss, and easy to freeze in winter.After-sale serviceThe best choice of well-known brands and the strength of dealers (longer distribution time, product quality complaints rate) of the water heater. Because the solar water heater is durable consumer goods, and usually installed in the roof, once the fault, it is difficult to deal with their own. So the customer service service must be guaranteed, at present, the whole market free warranty period of 3 - 5 years.
- Q: Is it hot in summer and the water is hot in winter?
- Wall really electricity, as to what the effect depends on the brand. Hodge is certainly not good, the water temperature is low in winter. Now a lot of property to buy solar, generally for the hodge. As for the solar energy is better or you use absolute OK Himin - winter!!!
- Q: Is there any water in the solar energy to water?
- How much is the automatic water supply set level up to the number 2 can not need to fill 100 set automatic water temperature time to remove any fill
- Q: Now there is no sun, cloudy days can use solar products?
- At present, I have not found this kind of solar energy
- Q: Solar energy application technology, there is no prospect
- I'm making solar energySimply put: solar energy is a new type of energy, the most important feature is pollution-free and inexhaustible. Therefore, under the condition of large amount of conventional energy consumption and environmental pollution, new energy has become a trend.
- Q: Good solar polymer or monocrystalline
- Working principle: the light of the sun to the solar battery plate current generated through the inverter controller for battery charging, battery power through the inverter controller into DC or AC electric power supply (load), or through the grid connected inverter of direct energy input power grid. Solar photovoltaic system consists of solar cells, solar controller, battery (Group), such as the output power for AC 220V or 110V also need to configure the inverter. In the specific design of system engineering, the following factors should be considered:
- Q: What are the references of the solar automatic tracking system
- Tracking models were taken; gives the specific design ideas and methods of photoelectric tracking mode; to analyze and determine the sun trajectory calculation method, verified the feasibility of this method. According to the proposed tracking method, design a set of automatic tracking type independent solar photovoltaic power generation system. The system is a small photovoltaic power generation system based on automatic solar tracking, all-weather, high efficiency run independently, as much as possible the conversion of solar energy into electricity, to provide electricity load. The whole system is divided into automatic tracking system and two subsystems of solar photovoltaic power system, the photovoltaic power system is in the forest fire specific applications are analyzed and designed respectively. The design of hardware and software of the two subsystems. The hardware design includes the position of the sun and light intensity detection, calculation The software part of the system is designed, which is composed of computer control, data acquisition, external clock and photovoltaic power supply
- Q: Buy solar water heater mainly look at what?
- Second, liner thickness. The quality of the liner determines the life of the water heater, if the water tank, the water heater will be scrapped. Major brand manufacturers use thickness of not less than 0.5mm of SUS304 food grade stainless steel liner. Argon arc welding is adopted to ensure the service life can reach more than 15 years. Other brands of water heaters in the liner between 0.2mm-0.4mm, the use of a period of time there will be water leakage problem. Therefore, consumers in the purchase of products must ask the thickness of the liner. At the same time, but also beware of patch water tank, the water tank liner is made up of a number of scrap steel belt, the entire inner bladder welding as many as dozens of times
- Q: The steps of making solar technology stubs
- 1 with a brush clean eraser material: big eraser, waste brush.Tools: scissors, glue.
Send your message to us
pv interconnect ribbon ribbon family
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- 339 ton kg/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords