Large Block (S Tread & Z Tread)OTR Tyre,L3/E3/G3

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Our OTR Tire list Items:

OTR Tyre :

L-3/E-3 29.5-25 26.5-25 23.5-25 20.5-25 17.5-25 14.00-24 16/70-24 16/70-20 12.00-16 8.25-16 7.50-16

Suit for construction machinery transporter in mine and other building sites

With excellent traction cut-resistence and avulsion resistance features

Large Block (S Tread & Z Tread)OTR Tyre,L3/E3/G3

Q: People say that big truck tires are best filled with nitrogen. Why is that?: But the high temperature causes the tire rubber aging, the fatigue strength drops, the tread wear is fierce, is also the important factor which possibly the tire burst. Compared with the general high pressure air, high purity nitrogen for anaerobic and almost free of moisture without oil, its low thermal expansion coefficient, low thermal conductivity, slow heating, reducing the tire heat accumulation rate, non combustible nor combustion characteristics, so it can greatly reduce the chance of puncture.

Q: Why are the outer tires behind the car worn?: There are many reasons for wear on the side of the tire: the vehicle is running off, the load is on one side, the regular route is fixed, driving habit and so on, which will cause wear on the side of the vehicle. This is also difficult to avoid, so one of the regular maintenance of the vehicle is a tire exchange.

Q: Is truck tire 650R or 700R fuel-efficient?: That LT doesn't mean the tire is all steel or semi steel.

Q: Is the tire good or small?: See what you run the road, the road is different, the tire size requirements are not the same

Q: What's the reason for the tire delivery?: Eat this tire a lot of problems, it is half angle and toe distance, but considering your car is generally not in the two, it should be hard tyre rim, wheel out of roundness under the condition of dynamic balance is not enough, you can confirm in the garage under the problem where, if there are any problems that steel ring is replaced, the conditions do not allow the words on the two front tires in the back and then get behind the normal tire wheel, and so on, every month for a tire it no matter where they can be effectively solved, but personally recommended to have confirmed off no problem.

Q: Truck vacuum tire assembly and disassembly process: Directional tire attention: correct installation for best performanceAn arrow with a directional tread design is provided with an arrow at the shoulder edge of the truck tire to indicate the direction of installation when the tire is transposed. For optimum tyre performance, directional tyres must be properly mounted to the rims to ensure that they are mounted on the vehicle in accordance with the requirements of orientation.For example, when a directional drive tire is fitted to the 8 wheel rim, you can use the rim groove as a reference. The four tyres shall be mounted to the left of the operator according to the arrow, and the other four tyres shall be mounted on the right side of the operator according to the arrow. This ensures that when the wheels are mounted to the vehicle, all the tires point to the correct transposition direction.When the wear of the directional tire exceeds 50%, generally, it is installed in the opposite direction of the transposition direction, which has no negative influence on the driving.On the other hand, the direction of tire wear from 50% new tires into the period, according to the reverse direction of the tire installation, will lead to an early start to tire irregular wear, excessive noise, and will shorten the life of the tread.

Q: How often do you need to change the tires?: However, as long as the sidewall of the tire is not impacted and the cord is not broken, it can continue to be used. The triangle mark on the side wall of the tire can help the owner find a protuberance in the groove of the crown, and can determine the actual wear limit of the tire. The value should be greater than 1.6 millimeters.

Q: Truck selection of tires?: A long distance truck should be used so that all steel radial tyres can be used.

Q: In what case do you need to change the tires?: Tread loss approaching wear markAny brand of tyre will have a wear mark at the bottom of the tread groove. The wear mark height of the general car tire is 1.6 millimeters (this height is also the minimum groove depth of the legal tyre), and the abrasion mark on the heavy tire is 2.4 millimeters.

Q: How to distinguish the quality of automobile tires?: The pattern and color of tire, from the lines, because of inferior retread processing is not standardized, so the relatively shallow groove, and the tire retreading is usually the color particularly bright, while the new tire is not normal.

Send your message to us

*Email

*TEL

*Quantity

*Unit