flat tempered glass cover Highbay Lighting F-03SC

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Body:Die-cast aluminium.

Optical system:Anodized aluminum reflector and flat tempered glass cover.

Finishing:All die-casting components after mechanical and chemical anti-corrosion treatment, uv resistant exterior paint system.

Light output:Narrow, wide angle light option.

Electrical assembling:Alone electrical box.

Fixing:Lyre fitting joint or hanging.

Control:Sensor control option.

Die-cast aluminium body.
Surface anti-ageing electrostatic spray processing. Supporting the application of all kinds of high shed lighting

flat tempered glass cover Highbay Lighting F-03SC

Q: What are the common driving power of led industrial and mining lamps?: By using a capacitor through the charge discharge to drive current, simple circuit, low cost, but the performance is poor, poor stability, voltage fluctuation and easy to burn LED, while the output voltage of non isolation insulation protective shell. Low power factor, short life, generally only suitable for economical small power products (less than 5W).

Q: What's the difference between industrial and mining lights and floodlights?: Floodlight can be divided into explosion-proof floodlight and general floodlight, industrial and mining lights must be explosion-proof. The light source can be used the same, mainly the shell and the difference between the tightness. Of course, there are many.

Q: How to install industrial and mining lamps?: Fix the convex lens on the lamp body and pay attention to the hole position. When placing the correct position, the COB light source should be in the middle of the convex lens, and the screw should be tightened!

Q: What is the difference between the l e d projector and the industrial and mining lamp?: Mainly used in large areas, mines, buildings, contours, stadiums, overpasses, monuments, parks and flower beds, etc.. As a result, almost all outdoor lighting fixtures are considered light emitting lamps.

Q: How about UFO industrial and mining lamps in foreign markets?: Wide range of power, 80W~250W optional; three, by LED and lens light, save the reflector, greatly save the transportation costs; four, light efficiency of up to 120lm/w; five, lamps warranty for five years.

Q: Why is led mining lamp longer than traditional metal halide lamp, industrial and mining lamp?: Life: to the current technical level and the test result calculated, LED mining lamp life can reach 50000 hours, and working life of traditional metal halide lamp is less than 5000 hours, an average of less than one year to be replaced once, some even 3 months to replace a.

Q: What are the light areas of industrial and mining lamps?: How high is the hanging, as well as the required illumination, uniformity, which will be more specific

Q: What is the maximum installation distance of industrial and mining lamps?: The installation of industrial and mining lamps should be calculated according to the length, width and height of the factory building according to the illuminance requirements. LED lamp has incomparable advantages in small power lighting, but it is better to choose electrodeless lamp in high-power lighting.

Q: What are integrated industrial and mining lights?: The LED is packaged together as a whole, not a single one.

Q: LED what are the differences between 45 and 120 degrees angle lighting for industrial and mining lamps?: Generally 10 meters high warehouse suggested using small angle of industrial and mining lights, angle is too big, the ground illumination is too low.

Send your message to us

*Email

*TEL

*Quantity

*Unit