3M Double Sided Tape - Double Side PET Clear Tape Heat Resistant with High Quality
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 50 roll
- Supply Capability:
- 500000 roll/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Quick Details
Material: PET film
Adhesive Side: Double Sided
Adhesive: hot melt,water based acrylic,solvent based acrylic
Liner:white release paper,yellow glassin paper,red film
Design Printing: Offer Printing
Place of Origin: China (Mainland)
Standard sizes: 50mm x 50m, 1.02m x 1000m, etc
Application:widely used for carpet fixing,flying splice operations on film,bag cover
sealing,bounding,foam lamination and others.
Product Discription
Applications
widely used for carpet fixing,flying splice operations on film,bag cover
sealing,bounding,foam lamination and others.
Advantages:
• Multi-colour, available in a wide range of colours
• Humidity resistance, superior resistance to heat and water
• Excellent adhesion characteristics and high strength for bonding results
• High flexibility and strong tensile strength promote durable properties
• Able to remove cleanly without leaving any residue
• Non-toxic with low acid content and safe in term of health
• Multi-colour properties tend to fulfill any application requirements
• Excellent viscosity and well conformable on smooth or rough sufarces
• No distortion on cuts, cuts without leaving zig-zag pattern on the edges of tapes
• Use indoor and outdoor due to good performance over a wide range of weather temperature
- Q: How do you apply double-sided adhesive tape?
- 7, in the printing process to clean the printing plate, should avoid cleaning solvents, contact tape, so as not to damage the tape;8 when the plate is removed from the tape, the angle between the plate and tape shall be no more than 90 degrees.9, the interface version of the place to stay 5mm or so, the use of 3M 1600 electrical insulation tape seal version of the effect is good, you can effectively avoid wiping the plate caused by the interface version of the resulting ink pollution, and very economical.10, double-sided adhesive over repeated use can produce overprint bad phenomenon, especially in the new situation, and used for a long time in registering are likely to happen.
- Q: There is double adhesive mark on the back shell of mobile phone. How can I clean it up?
- 1. Take a piece of dry cloth covered with vinegar and cover the whole area with double glue marks. When the adhesive on both sides of the adhesive is completely soaked, remove them with a ruler.
- Q: What's the material of PE foam double release tape? Urgently!!
- The base paper of the release paper is usually made of the bottom paper of double adhesive tape with Grasin and self-adhesive paper. Dongguan Kai Cheng paper from type paper, base paper.
- Q: How do you remove the foam glue on the wooden floor?
- 4, rubber to division, for a small piece of double-sided adhesive residue, you can use the white eraser at home, directly on the floor to wipe, the same can be double-sided adhesive removal.5, toothpaste to division, you can take white toothpaste coated on double-sided adhesive, and then use a clean cloth slowly erase
- Q: There are several kinds of tape knowledge
- According to the scope of application division can be divided into:Warning tape, carpet tape, electrical tape, protective film tape, winding tape,Sealing tape, die cutting adhesive tape, etc..4, according to market penetration rate can be divided into: ordinary adhesive tape, special adhesive tape.5, according to the application of environmental temperature division can be divided into: low temperature tape, room temperature tape, high temperature adhesive tape.
- Q: Coating process of organic silicon high temperature double faced adhesive tape. The substrate is PI or PET film.
- My company has done this thing, remember it is not PET, PI is not sure.
- Q: Construction method of butyl adhesive tape
- (4) tear off the insulating paper on the top of the Yongxing adhesive tape and press the metal plate on the upper layer of the interface into the jointOrderly extrusion joints, so that the joint bond firm, closed tight.(5) tighten the screws so as to bond the upper and lower bonding surfaces of the adhesive tape. (1) pre installed above the parapet gutter gutter, the cement surface clean, brushing and base treatment.(2) the primary treatment agent suspected solid after installation of the water board, to ensure that the installation is firm and closely combined with the wall.(3) the water board will wipe clean, paste on the joint water board and cement wall in Yongxing according to the order of a single sided aluminum foil tape, the bonding agent pressure;
- Q: What's the chemical composition of the double adhesive?
- The adhesive composition, according to different brands, different types have different kinds of polymers.
- Q: 5 cm double sided glue. How many meters per roll?
- Generally about 3 meters. You can go to Taobao or hardware store to see, sell a lot
- Q: How can I get the double glue glued to the door?
- 5, if these things are not available, you can apply white toothpaste on the double-sided adhesive, and then erase slowly with a clean damp cloth.6, if it is in the field or work place, you can choose to use hot water or cold water wet it, and then scraped (relatively slow)
Send your message to us
3M Double Sided Tape - Double Side PET Clear Tape Heat Resistant with High Quality
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 50 roll
- Supply Capability:
- 500000 roll/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
