Specifications Of Cloth Tape CG-70 For Industry:

1. The cloth duct tape is with hot melt adhesive.

2. The backing cloth is PE coated.

3. The tape is waterproof and easy tear by hand.

4. Different colors available: silver, black, white, red, green, beige, yellow, blue and so on.

5. Mainly used for pipe wrapping, air-conditioner ductwork, heavy duty packing, carton packing, carpet installation, protection of surface, bundling and sealing.

6. Two standard ways for cut roll packing: one roll per shrink & one roll per plastic bag. We can also offer special packing as per customer's requirements, such as label, core printing and sticker.

CONSTRUCTION Of Cloth Tape CG-70 For Industry:

Backing: polyethylene cloth (assorted colors)

Adhesive: Hot melt rubber adhesive

TYPICAL PHYSICAL PROPERTIES Of Cloth Tape CG-70 For Industry:

Total Thickness (adhesives + carrier): 200-220micron

Cloth mesh: 70

Initial Tack: ≥15# steel ball

Holding power: ≥2h

180°Peel Adhesion (to stainless steel): 16N/25mm

Tensile Strength: 40N/cm

Elongation: ≥20%

PACKING Of Cloth Tape CG-70 For Industry:

Core I.D.: 3" (76mm)

Jumbo Roll: 1.06 x 500m/1000m

Packaging: Wrapped with corrugated cardboard.

Cut Roll: roll width 3mm up

Transport Information Of Cloth Tape CG-70 For Industry:

Not a hazardous material for DOT shipping．

UN：None

Packaging sign：According to the buyer

Packaging Category：No information found/According to the buyer．

Shipping Marks: According to the buyer

Remarks Of Cloth Tape CG-70 For Industry:

1.         The data above are typical results and subject to change without notice.

2.         Tolerance: Weight and Thickness: ±10%; Width: ±3mm; Length: Cut Roll & Log Roll ±0.3m, Jumbo Roll ±0.5%.

3.         The products should be stored at room temperature and be kept away wet and/or heat source.

4.         It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied must be clean, dry, and free of grease and oil.

5.         The users should take test and do trial-application on the above products before coming into application so as to witness and ensure suitability for their special purpose and technique.