42 Inch Rs232/Usb Controller Ir Multi Touch Screen(Size10.4&Quot;-120&Quot;)
- Loading Port:
- Shenzhen
- Payment Terms:
- L/C,T/T
- Min Order Qty:
- 1 Piece unit
- Supply Capability:
- 500 Pieces per Week unit/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
42 inch RS232/USB Controller IR Multi Touch Screen (Size10.4"-120")
Specification
MECHANICAL | |
P/N | CIL420-4K-T2-A |
Housing | Aluminum frame |
Touch panle size(mm) | 990.6*582.6 |
Active area(mm) | 936*528 |
TOUCH CHARACTERISTICS | |
Input Method | Finger or touch pen(Six points touch) |
Touch Activation Force | Non Minimum activation force |
Position Accuracy | 2mm |
Resolution | 4096(W)×4096(D) |
Response Time | Touch: 8ms |
Drawing : 8ms | |
Cursor Speed | 120 dot/sec |
Glass | No glass or 4mm glass,Transparence : 92% |
Optics Number | 156(W)×88(D) pcs |
Optics Cell Area | 6.0*9.0mm |
Object Touch Size | ≥ Ø5mm |
Touch Intensity | Over 60 millions single touch |
ELECTRICAL | |
Operating Voltage | DC 4.5V ~ DC 5.5V |
Power | 1.0W (200mA at DC 5V) |
Anti -Static Discharge (Standard :B) | Touch Discharge,Grade 2:Lab Vol 4KV |
Air Discharge,Grade 3:Lab Vol 8KV | |
ENVIRONMENT | |
Temperature | operating:-10 °C ~ 50 °C |
storage:-30°C ~ 60 °C | |
Humidity | operating:20% ~85% |
storage:0%~95% | |
Relative Humidity | 40 °C,90% RH |
Anti – glare Test | Incandescent lamp (220V,100W) , operating distance over 350mm |
Altitude | 3,000m |
Interface | USB2.0 full speed |
Detection Method | Infrared rays |
Seal Ability | IP65 |
Working Environment | Under sunlight ,indoor and outdoor |
Application of Display | LED,LCD,PDP |
Software(Firmware) | |
Scanning | Auto full screen scanning |
Touch Trigger | Drop,raise,move on plane |
Output | Coordinate output |
Install
A:IR Touch screen consists of four aluminum article,normally,the four aluminum article are connected,
and glued with the glass,for the convenience of transport and save shipping cost ,it also can
be separated when delivery.As you can see in the following graph 3.2a;
B:If the article aluminum alloy is separate,Assemble it according the step of 3.2b-3.2e. As follows step:
In Exhibit 3.2b,to pump PCB board from A1 port ,connect A2 port FPC to A1 port FPC socket:
Pay attention : FPC socket is very precise,At connection PFC cable time, please follow 3.2c-3.2 steps :
a. Pull out the card buckle: please push out the locked card buckle of FPC socket in direction of arrow ,
as 3.2c shown ;
b. Insert the FPC: Push A2port ribbon wire into FPC socket ,blue face up, as 3.2d shown ;
c. Lock the card buckle: push Card buckle of PFC socket in direction of arrow,as 3.2e shown;
FAQ:
Q1: Can dust damage electronics?
A: Dust and electronics do not make good friends. The thicker the layer of dust is on a
circuit board the more chance there is of a short depending on the nature of the dust.
Q2: Are electronics cheap in Okorder.com?
A: Of course. They are very cheap. The factories provide the goods. One-stop sourcing.
Q3: Why are electronics so cheap in ok order?
A: On ok order they are the lowest price. Because it is a wholesale website and factory
provide goods.
- Q:I would like to ask a computer touch screen LCD, how to receive the computer, in the WIN7 system to use touch. The monitor has three lines, one is the power adapter, one is the VGA line, and the other is the cable line. The same thing I saw in the bar, but I turned the USB line through the bar and got it to the computer. System is not recognized. What else do you need? The bar is the same way. But the host computer is for KTV only. It can also be called an ordinary computer host. But as for the software, I didn't read it. So I want to ask you, master. Don't be cold, please. Thanks, brother.
- The monitor cannot have network interface! It's probably a touch machine!
- Q:The notebook is a touch monitor, but the system shows it like this
- Run the touchscreen again
- Q:How to access the computer touch screen display, what hardware and software specific needs, and the installation process, please note Xiangxi
- These DIY are very risky. Generally, the monitor supports the touch. You see the principle of mobile phones,.DIY is troublesome and easy to break
- Q:LCD touch screen monitor how to maintain, should pay attention to what?
- Affixed to the screen protection film, because fingerprints are not wipe off, and rub it will damage the surface of the material, pay attention to anti fall, after all, is the glass of things, broken, it will not repair well
- Q:The company just made a touch-screen computer, DELL. How to set touch screen mode? Why not order ah?Do you have any special settings?
- Do not need to set, as long as the installation of the system, install the driver, just like the mouse.Nothing special.The system is out of order, and the touchscreen itself needs a higher system.The touch screen display allows the user to just use your fingers to gently touch on the computer screen icons or text can be achieved on the host, so get rid of the keyboard and mouse operation, make the human-computer interaction more straightforward.
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
42 Inch Rs232/Usb Controller Ir Multi Touch Screen(Size10.4&Quot;-120&Quot;)
- Loading Port:
- Shenzhen
- Payment Terms:
- L/C,T/T
- Min Order Qty:
- 1 Piece unit
- Supply Capability:
- 500 Pieces per Week unit/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords