Metal Corner Tape

Hot Products

Peel Ply-vacuum infusion process fiberglass

Vacuum Bagging Film-vacuum infusion process

Straight for the metal bead belt Protection of Angle of galvanized steel tape Angle belt, aluminum Angle bead belt

Aluminum Metal Corner Tape

Metal Corner Tape-Aluminum

Paper Drywall Tape

PVC Corner Bead-EA

PVC Corner Bead With Fiberglass Screen Mesh-EA01

Metal Corner Tape

Metal Corner Tape-Galvanized Steel:1

FAQ

Indoor beauty glue, how can you hit the corner, playing perfect?

General use of aloe vera gel, as long as regular manufacturers are available. Including perfect products.

Plastic products surface of weld line, how to deal with the clip

Almost all products have weld lines and are difficult to eliminate completely.

IKEA corner wardrobe 96cm size, why 73cm?

Before buying, you can understand the material, size, and how to install it on the website. No domestic furniture company can do it!

Large angle hinge is used at the corner of the cabinet

They are high-end products, the general accessories are pure imports, new technologies and technologies are also used more. So I should know, I hope I can help you!

What skills do you have in turning corners and corners of integrated wiring?

Specific practices are as follows: the bottom line groove need to turn the place with the square to draw 45 degrees line, and then use the iron scissors along the line position is cut off, the slot can be riveted lap bending. The line groove cover can be made by this method when it is bent horizontally at 90 degrees.

Does it need extra money to decorate the corner of the plaster line?

This is extra. Corner and corner are 2. The corner is more expensive than the corner line

What do you mean by corner steering of Bao Chun 730ABS steering wheel?

The steering wheel sensor usually uses three mechanical structures to measure the angle and the number of turns. The large gear rotates along with the steering tube column, and the teeth of the two pinions differ by 1, and are fixed in the body with the sensor casing, and do not rotate with the steering wheel. The two small gears are respectively collected with the rotation angle of the steering wheel, and because of the difference of one tooth, the number of different turns will be different from the specific angle, and the absolute rotation angle of the steering wheel can be obtained by calculation.

Pcliao injection of smooth surface not light is going on

This defect is commonly believed to occur frequently during die filling and pressure holding. In fact, dark spots appear near the gate and usually occur at the beginning of the injection cycle. Tests show that the occurrence of surface slip is actually due to the injection speed, or rather the flow velocity at the tip of the melt flow.