Chromium In Stainless Steel

Hot Products

Manhole Cover D400 Ductile Casting Iron Casting Components

Ductile Iron Manhole Cover ΕΝ124 Made In China Good Quality On Sale

Manhole Cover Ductile Iron Square on Sale

Manhole Covers Ductile Iron EN124 Black Bitumen Coating

Manhole Cover Ductile Iron EN124 D400 Bitumen Coatings

Manhole Cover EN124 D400 Made in China on Hot Sale

Manhole Covers Ductile Iron GGG50 D400 EN124

Manhole Cover EN124 GGG40 Ductule Iron C250 Bitumen

Manhole Cover Square Base with Round on Sale

Ductile Iron Manhole Covers Top Quality Made In China

FAQ

How to get rid of casting sand inside casting parts?

Are you saying that in the sand casting cavity? We use the manual blast, he is like a pipe will be automatic shot out of the grit, into the casting cavity, to remove the internal cavity in the purpose of casting sand!

What are the general technical requirements for casting parts?

According to the national standard GB/T 9438, there are 8 aspects: 1. chemical composition; 2. delivery status; 3. mechanical properties; 4. dimensional tolerances; 5. weight tolerances; 6. appearance quality; 7. internal quality; 8. casting salvage.

In theory, which is more expensive, forging parts or casting parts?

The structure of the casting is relatively flexible in design, and the modeling is easy to realize.

ZGMn13 casting parts processing, with what knife head good?

The ZGMn13 itself is not have processing, if only the processing point, sharpening, ordinary can, if the processing area is relatively large, ZGMn13 external impact load is bigger, its surface wear resistance is high; the two is with the gradual wear of surface hardening, the hardening layer is continuously formed new if you have suggestions, processing, plasma cutting or flame cutting try

How do casting parts remove stress?

Annealing treatment, according to different casting annealing treatment, eliminate thermal stress, if need to restore hardness or increase hardness, and then quenching treatment

What is the casting material?

The casting material is usually made of gray cast iron, nodular cast iron and vermicular graphite cast iron

The casting sand is going on

2, causes(1) sand mold (core) strength is not high, when the box a little reason will fall off.(2) the strength of sand mould (core) is not high, it can not stand the erosion of molten steel.(3) box sand mould (core) crush.(4) high strength under high temperature, warpage, deformation and protuberance into the cast steel under the action of high temperature molten steel.(5) the floating sand in the air hole of the sand mold falls, especially when the floating sand falls in the casting, and the floating sand on the surface of the sand mold is easy to fall through the air vent.(6) when the box is closed, the surface of the mold cavity and the surface of the sand core are not cleaned, and the sand (core) surface has floating sand and so on.

What should I pay attention to when designing a casting structure?

1 of the casting in metal mold cooling was faster than sand, metal type and let, thus casting in metal mold casting, casting stress generated in the ratio of sand casting to crack tendency is also large, but also prone to misrun and cold lap, white (for casting casting). Defect. Usually: (1) in the prevention of metal casting casting crack aspect should pay attention to the following problems: the structure of A in wall thickness, wall transition and connection to the ease, corner fillet appropriate requirements such as should be more strict than sand casting; B should be connected vertically connected with the wall to tilt C; for the weak parts of the structure should be set to strengthen ribs, bosses, to prevent casting; D should minimize the obstacle free shrinkage of the boss, casting rib, flange and other prominent part; E in the casting arrangement of ribs, but also should consider its influence on the casting shrinkage.