Tamales In Aluminum Foil

Hot Products

FAQ

I have a Wirlpool dryer model WED7500VW0It's a little over a year old, and saw minimal usage, as we were away 6 month out of the year.Today I tried drying the clothes, put it to normal dry,as always, and noticed that the glass door became wet after a little whileI stopped the dryer and opened the door, it was really wetThere was heat inside the dryer, but when I touched the clothes, it was wet.I dried the door and put the 20 min cycle onSame result after 20 min.PS: I checked the lint collector and it was clean, which is unusual after 20 min drying.What is wrong with the dryer?
the problem is in the vent hose.You need to find where the dryer vents outside.it may have water in it that froze and created a block of lint and ice or it may just be clogged with lint.usually happens at a bend or crease.PLEASE NOTE THAT THIS IS HOW MANY HOUSE FIRES START!.The air is not getting outside.If you have flex hose check every bend and check the outlet in the back of the dryer at the bottom where the vent or flexhouse attaches to your dryer.for emergency drying like have to work in the morning, disconnect the vent from the dryer, pull it away from the wall a bit, put a piece of aluminum foil or something metal against the wall where the vent will be blowing and let it vent in the house then find the clog in the vent tomorrow
I have a Grossman bike, and my seat tube is abit highAs i am riding street, i need it to be lowerI've put my seat post all the way down but still, when i'm riding, it feels as though im riding a Xcountry bike.Need help guiding how to cut the seat tubeShould i?
maybe you can go to some can factory or to a recycling place they should have some cans there or go to a local craft store they might have something there i still say that rubbing the cans with sand paper is a good idea maybe get some friends to help you out a bit you can get alot of work done with team work ok i hoped i helped good luck ;D
i have an aluminum intake for my car and i need to cut a little of the length off but with how much i need to cut off it would cut a nub off for the vacuum hosei was wondering if i could just drill a hole, sand and prep the area and the nub, and then jb weld the nub over the drilled holewould it hold? theres no extreme heat on the tube and no extreme pressure.thanks
I wouldnt trust it to be a permanent fix on anything
i'm blondei want just like a streak of blue in my hairlike aqua marineDoes Kool aid actually work??? how long would it last and how do you actually do it.?
Yes, it doesIt will last a couple of weeks, depending on how light your hair is, and how often you wash itDon't make it like you were making regular Kool Aid thoughAdd about 2 cups of water to the packet, and then boil it for a few minutesLet it cool, and put it on your hairUse some aluminum foil to separate itGood luck!
So this is the problem, i sweat wayyy too much on my armpits for no reasonI started using the lady speed stick which is a antiperspirant/ deodorantThough it has a powder like smell which makes my srmpits smell weirdI just wanna know if i can wear that one and use a different one over it- secret gel deodorant
No, not reallyI've made blackberry jam before with frozen berries, it tastes just as good as fresh berries in my opinion.
For example, I have this science question that I just don't understandThe formula for aluminium oxide is Al2O3Why does the formula have two aluminium atoms every three oygens? I really don't understand this so a good easy to get answer would be appreciated, thanks!
I think I see what you're asking When you write the formula of an ionic compound subscripts are used to represent the ratio of positive and negative ions in the ionic compoundThat's done by finding the charge of the element and flipping them around(like you are thinking) But when your dealing with molecular compounds like: 2 H2+O2- 2 H2O you have to balance them differently as you can see The last part I put may seem confusing but that's because water is a covalent compound and not ionic.
I used quot;Lady Speed Stickquot; Invisible Dry Passion Flower but I am still sweating and it is leaving YELLOW STAINS on my white T-shirtOh and btw the one that doesnt have Alluminium in it??? 10x :P
Its important to assume the best of peopleIt could have been just about anythingShe didn't say anything so why label her as either racist or just a bimbothere are many possibilities: maybe she just was not in the mood of talking, or she was out of breath and so on and so forth.
Ive been reading all this information on making a TurkeyIts my first year, and Ive had to deal with my grandmother's really dry turkey my whole life hahaSo I learned that you should make a brine, and let it sit in the refrigerator for about 2 days before you use it, and when you do, you should let your turkey sit in it for 24 hours before baking.I was reading other recipes, and watching other chef's birds and they usually mix herbs in their butter before they rub the bird.Would it be too much to do both? I know that when you bake the turkey you should put it either in a bag or a little aluminum foil over itWhich is best? I also know that you shouldn't stuff it, that it can cause uneven cookingIve seen chefs put some vegetables in the cavity to add some more flavor (onions,celery,carrots) Would this be too much flavor too?I know that you should let it sit for 20-30 minutes to let the juices and flavor redistribute.Any other helpful tips?Thank you :D
People have been making turkey long before Alton Brown was aroundWho says it is his idea? Prepare the brineYou can do it in advance, but no need toTurkey sits in the brine over night or up to one dayThe longer it is there the saltier the bird will beDon't overdo it Add a rub - wet or dry - the rub adds additional seasoning to the birdYou can make a butter and herb rubIt goes under the turkey skinVeggies in the cavity are fine if you are roasting the birdEmpty cavity if you are smoking itWe use citrus and onion and whatever else is on hand - lemon usually, but again it us whatever we have on handBeen doing it long before anyone ever heard of Alton Brown When we are roasting we do not use a bagTotally unnecessary itemI'd skip itAs another contributor suggested if part of the bird is getting too brown put on some tin foilAny other tips? Pat yourself on the back when you are done and make sure to enjoy your meal.