Stacked Stone Panels Exterior

Hot Products

Moistureproof fireproof wave decorative gypsum board

Gypsum Board Good Quality ,Low Price Acoustic Perforated

Gypsum Board/ Drywall/ Plasterboard / Interior Wall Panel

Gypsum Board/ Drywall/ Plasterboard/ Interior Wall Panel

Gypsum Board Cheap Roofing Material Fireproof Exterior Wall Panels

Gypsum Board Good quality Low Price Acoustic Perforated

Acoustic Perforated Decorative Panel, gypsum board, mgo board

Cheap Price Gypsum Board with Standard Size Factory

Gypsum Board The Standard For Wall Partition

Gypsum Board Good Quality Low Price Acoustic Perforated

FAQ

Gypsum board wall batch of gray do not brush latex paint can be directly posted wallpaper?

Gypsum board wall batch of gray do not have to brush latex paint can be directly posted wallpaper, if the brush latex paint paste wallpaper, but may be used in a long time yellowing drum off.

9 meters, the closet to do 2.4 meters high and then gypsum board cap or directly to the top of the rough layer height of about 2.9x meters

Mainly to see you more attention to which aspects, so the top of the words, increase the space of the closet, but not beautiful; gypsum board capped, wardrobe space will be less, but the effect of the wardrobe will be better.

Gypsum board ceiling installation corner must be seven-shaped

You should say is mineral wool gypsum board bar (specifications 600 × 600 or 600 × 1200), the corner must be used piece "L" type, or take the sub-bone and edge aluminum. Norms also have this requirement.

Will the brick wall and beam column cracks, cracks between the board, gypsum board cracks how to deal with

Masonry and beam column cracks, can be at the junction of nail steel mesh or fiberglass cloth, and then plaster;

Ready to decorate, will the sauna board ceiling and gypsum board ceiling, the price of the two?

Of course, is to use the sauna board to do the ceiling, the cost is higher ah

I installed the lights on the gypsum board on the screw, not the kind of embedded lights

Installed relatively light, pull a few support lines on the lamp lock on the screw, expand the force point, you can achieve beautiful and practical function

Gypsum board brush latex paint how to deal with yellow

Latex paint yellow the best way to deal with the original paint layer is to remove the exposed base surface, red putty, and then brush latex paint. Latex paint yellow may have the following reasons: Local leakage or grass-roots level of gypsum and putty, the water is not fully distributed on the late coat paint. Latex paint is uneven, latex paint in the process of brushing have the order, because the latex paint are water-based materials, easy and air oxidation reaction, a long time will change, so the first brush is easy to start to turn yellow, If your latex paint is not done in a certain period of time, this may happen. And latex paint done, there will always be some tinkering, so the general experience of the construction will be the second and third times the latex paint separately, to be repaired in the brush last time, so the probability of yellowing will be Greatly reduced Grass-roots anti-alkali caused by local yellowing, you can consider drying with sandpaper polished directly painted again anti-alkali primer, twice the finish, or remove the yellow part of the putty, in the grass-roots layering agent, Paint once again painted twice.

Causes of Cracking of Gypsum Board Ceiling Joint and Its Treatment

In fact, sticky bandage, kraft paper are not too, the best way is to use nylon cloth 5 ~ 6cm wide, nylon fabric weave texture composed of two directions, cutting time along the latitude and longitude along the cut, not beveled. Grass-roots treatment clean and flat; this can be a long time to keep the surface latex paint does not crack.