Single Phase Inverter

Hot Products

Frequency Driver VFD Inverter for Solar Panel

Variable Frequency Drive 6KV 1250KW VFD

High Voltage Frequency Drive 10KV 500KW VFD

High Voltage Frequency Drive 6.6KV 450KW VFD

Variable Frequency Drive 6KV 1000KW VFD

High Voltage Frequency Drive 11KV 630KW VFD

Variable Frequency Drive 3.3KV 850KW VFD

Variable Frequency Drive 6KV 280KW VFD VSD

Medium Voltage Variable Frequency Drive Inverter

High Voltage Frequency Drive 3.3KV 1000KW VFD

FAQ

Inverter alarm a043, how is it

When a signal failure occurs, use the DTI board, if necessary, change P215. With P806 (Follow the parameter description) during operation can be converted to no encoder operation A043 is: n-actjump exceeds the allowable change speed of the speed encoder signal (P215) In addition, for the synchronous motor (P095 = 12): The motor speed is 2% higher than the inverter release time point. The inverter in the ready state can not exit. Check processing: Check if the cable is disconnected Check the tachometer to shield the ground Not only on the motor side but also on the inverter side The encoder cable does not allow disconnection Use only recommended encoders The encoder cable is not allowed to be laid with the power cable

What is the difference between the collector and the emitter mode?

While the base area should be very narrow So bjt is not a symmetrical device

Can the four motors be tuned to 2900 rpm?

Will be affected, under normal circumstances overclocking is possible, but speed is not possible.

Octopus AC Servo motor can be driven with ordinary inverter?

If it is synchronous motor, it depends on whether you choose the inverter is compatible with the synchronization machine, most of the incompatible. As you said the situation, the motor 8 pole, may be synchronous motor. Specifically, you can compare the rated speed and rated frequency to see if there is a slip rate to determine whether it is synchronous or asynchronous motor.

Can the laptop's power adapter be used for years?

In the power adapter has a nameplate, marked above the power, input and output voltage and current and other indicators, with particular attention to the input voltage range, which is the so-called "travel power adapter", if the city voltage to only 110V country , This feature is very useful, and some parallel notebook computers are sold only in the origin, there is no such compatible voltage design, or even only a single 110V input voltage, in our 220V mains voltage will be burned to burn.

Is it possible to use a different laptop's power adapter?

For the power adapter, whether access to equipment, the following aspects of the measurement standards: Interface form The interface plug and socket used must be dimensioned. Voltage size The output voltage of the adapter is the same as the required voltage of the connected device (eg notebook). Inconsistencies may not be able to start or burn the device properly. Current or power The power of the adapter is greater than the maximum power required by the device. Power is not enough, may cause the voltage to drop, the adapter is hot, or burn the adapter. More than the above, the use of more power of the power adapter, while meeting the interface and voltage conditions, it can be replaced.

Can the notebook's power adapter be mixed?

This is a 90W power adapter This is Acer's 65W power adapter Here need to explain: General in the power adapter only shows the output voltage and current, not marked wattage, need to calculate their own. The value obtained by multiplying the number of voltages and the number of currents is the wattage. More on notebooks Related topics: Notebook forums hope that the above information is helpful to you

How to lift Yaskawa inverter base blockade?

Unlock the base block of Yaskawa inverter: 1. If the Yaskawa inverter reported that the base blockade, we should first check the cause, parameter settings in strict accordance with the recommendations of professional engineers to set.