Led Lights For Christmas

Hot Products

SMD3528 60 LEDS PER METER INDOOR 3 METER PER ROLL

led plant grow light strip solar led strip light

Bendable 5050 RGB led strip for corner of letters

Waterproof 24V RGBW Flexible Led Strip 4 Colors in 1 Led 120leds

led light strip diffuser channel amber flexible 5050 waterproof led strip light

12v battery powered led strip light SMD 5050 RGB

led motion sensor led strip light 5050 12vdc 60led/m with 24key remote controller

LIGHT STRIP SMD3528 60 LEDS PER METER INDOOR 5 METER PER ROLL

Flexible Light Low SMD3528 60 LEDS PER METER INDOOR 6 METER PER ROLL

Side Emitting Led Strip Light Cuttable Led Strip Light

FAQ

LED lamp and lamp with high and low points?

LED lights to light, you must have a power drive, high voltage means to connect high 220V use, with internal power driven.

What are the specifications of the LED lamp band and which ones are more commonly used?

LED lamp belt refers to the LED assembly in FPC band (FPC) or PCB hard, because of the shape of the product as a band name. Because of long service life (normal life expectancy of 8~10 hours), green and gradually emerging in all kinds of decoration industry.

Can anyone tell me what's the difference between LED lights and indoor and outdoor installations?

Outdoor installation: outdoor installation because will withstand the wind and rain, if the use of fixed 3M glue, a long time will cause the decrease of the 3M adhesive LED lights off, so often used for outdoor installation fixed card slot, need to cut and connected and installed in the same place, method, just need another with waterproof glue, waterproof effect to consolidate the connection point.

LED lamp with 180 beads, how many watts per meter?

The lamp lights with the general use of 20MA current, which is a is about 0.06W, so it is about 10W, but to consider a problem because there is resistance to limit the current, and therefore power resistance is not inside, if the use of low-voltage power supply (either 12V or 24V), its power 14.4W, which refers to the maximum power.

How many light slots should I leave for the LED light belt?

This size is OK, but LED and T are different, so you should put the line from the top to the bottom, because each LED has to connect to the power alone, and the T4 and T5 can be connected

LED can the band be cut at will?

Each of the 3 LED lamp 12VLED lamp with a module, modules can be arbitrarily cut.

What is the material of LED lamp belt?

The basic concept of LED: LED (Light, Emitting, Diode), LED is a solid state semiconductor device, which can directly convert electricity into light. The heart of LED is a semiconductor wafer with one end attached to the LED lamp strain on one bracket, one end with the negative electrode, and the other end connected to the positive electrode of the power to encapsulate the entire wafer with epoxy resin. Semiconductor wafers consist of two parts, one is P type semiconductor, in which the hole dominates, and the other end is N type semiconductor, which is mainly electronic here. But when the two semiconductors are connected, they form a "P-N" junction". When the current passes through the wire acting on the chip, the electrons are pushed into the P region. In the P region, electrons combine with the hole and then emit energy in the form of photons, which is the principle of LED luminescence.

Connect the LED light belt to change the electric wire!! the result electrify! The electric wire heating, the interface is electric hot, how to return a responsibility?

The wire interface is hot, indicating that the wires are not handled properly and have no good contact, resulting in contact resistance, leading to fever. Recommend using sandpaper carefully burnish thread parts, in accordance with the standard method of connecting wires, wires connected, and electrical insulating cloth, to ensure safe use of electricity.