Indoor Flood Light Bulbs

Hot Products

FAQ

My home led ceiling lamp is 3 color adjustable, but why every time the lights are about the same color, what is the way to solve ah?
The LED light source board in your ceiling lamp should be around two. There are two color temperature 3000K, 6000K and LED respectively. When 3000K and 6000K are lit at the same time, they are mixed into 4000K color temperature. If the line connection of the driving power is wrong, the color of the left and right may be inconsistent. You can fix the wrong side of the power line.
LED ceiling light mounted in the living room, with subsection and remote control. The first paragraph (the first switch) all lights are blue (color change);
If the switch is open properly, the switch is proved to be no problem.The sectional remote-control switch can normally control the remote circuit, and the receiver has no problem.It is estimated that the relay on the circuit board above, or similar relay aspects of electronic components.If you still have questions, ask again!
LED ceiling lamp, why is it bright after closing the switch?
Many people say that the off switch, lights and light or flash, actually not electrical wiring or lamps, energy-saving lamps and LED lamps are now popular, after a long line switch, power capacitor through the line of arrival between the lamp, accumulated to a certain voltage, the starting circuit light bulb. The resistance of a 470K ohm can be connected at the 220V entry line of the lamp holder to release the induced current, so that the problem of the light or flashing of the lantern can be effectively prevented. I also have electronic hobbies, LED lamp house flash is using this method to solve, some people say I don't agree with the capacitor, capacitor voltage because of problems, once the breakdown, short circuit will cause tripping, the resistance will not.
What is the LED ceiling lamp? What's the effect of the LED ceiling lamp?
Ceiling lamp installationWhen the installation of ceiling lamps, roof should be considered the situation Home Furnishing, if it is a masonry structure of the roof, the pre buried bolt, or with expansion bolts, nylon, plastic plug plug is fixed, not with wedge. Usually do not put too many decorations on the lamp, or more than the carrying capacity will fall down wounding.Although the ceiling lamp clings to the ceiling, some electromagnetic reactions will still absorb dust in the air when the lights are turned on. Should regularly check lamps and lanterns, if the foot contact, or starter loose, etc., should be promptly re installed and adjusted.Cleaning of ceiling lampCleaning lampshade can be carried out according to material. If it is glass, use a soft cloth, scrub it carefully, or clean with some toothpaste. If it is a crystal lampshade, it can be washed with neutral detergent. The dirt on the lamp holder is clean. You can remove the dust on the surface first, then wipe it with some cotton cloth. Don't leave the moisture on the lamp holder.When scrubbing the ceiling lamps, should use light colored cotton or cotton hand is in your hand, gently wipe the lamp, do not arbitrarily mobile lamp shrink machine inside the www.shousuoji components. If you want to wash your own ceiling lamp, then there must be two people to cooperate with, first off the power supply, but also pay attention not to use wet cloth to wipe the lamp holder, it is easy to cause leakage.
LED living room ceiling lamp has sectional dimming and stepless dimming, which is good? What kind of power saving and low energy consumption?
LED stepless dimming, if the use of TRIAC dimmer, light load efficiency will be very low, only about 10%. If the PWM dimming, the efficiency is very high, even light load can reach 80%
The LED ceiling light mounted in the living room will turn on the light after the power is switched off
Micro bright almost no power consumption, the impact on the lamp belt life is not great. However, this may indicate a problem with your switch or wiring. For example, a double switch (that is, two switches), or a small light on the switch. The leakage current of ground wire is large, and the problem of power supply design is likely to cause this phenomenon.
Led ceiling lamps for lighting, how many watts fit?
Family ceiling LED lamp band, can use 3528 of the lamp belt. Cabinet or closet with LED lamp, can use 1W or 3W. Like toilets, cabinets and so on, the use of LED ceiling lamp, can choose 8-15W ceiling lamp, detailed in accordance with the size of the area
How does LED ceiling light distinguish between good and bad?
The most important thing to see is the luminosity of LED, and second is the material!