Continuous Cast Iron Bar

Hot Products

Cast Iron Gate Medium Temperature Standard Structure: Gate Pressure: Medium

GATE VALVE AWWA/ ANSI NON-RISING STEM RESILIENT SEATED DUCTILE IRON

cast iron gate valve wooden box outside Standard Structure: Gate Pressure: Medium

GATE VALVE KNIFE DUCTILE IRON DN50-DN2000

GATE VALVE RISING STEM WEDGE DUCTILE IRON DN40-DN600

Cast Iron Gate Valve 15--60days Standard Structure: Gate Pressure: Medium

GATE VALVE NON-RISING STEM METAL SEATED DUCTILE IRON JIS

GATE VALVE SOCKET ENDS NON-RISING STEM RESILIENT SEATED DUCTILE IRON DN50 - DN300

GATE VALVE RISING STEM RESILIENT SOFT SEATED DUCTILE IRON BS5163

Cast Iron Gate Valve Resilient Seated Flanged Gate Valve Structure: Gate Pressure: Medium

FAQ

What is the difference between gate valve and gate valve? Is it the same valve?

The valve is driven by the valve stem to make vertical lifting of the plate inside the valve body.Gate valve is the same reason. The gate valve and gate valve have steel gate, parallel double gate and so on.So the gate valve and gate valve are the same valve. It's just a different name.

Stainless steel gate valve DN150 200300 weight, who knows?

Valve selection of different driving methods, connection forms, structural forms, nominal pressure, sealing surface materials, lining materials, valve body material will affect the weight of the gate valve more or less, it can not be generalized.Take my commonly used Z41H-16P (i.e. PN1.6MPa) series stainless steel gate valve as an example, and the weight of DN150/200/300 is 134/192/379kg. Of course, different manufacturers may vary in weight, but not much.I hope I can help you.

Why can't the pressure measuring point be set at the two ends of the gate valve when measuring the resistance loss of the gate valve?

Because of the unsteady flow of fluid near the inlet and outlet of the valve, the measured data cannot be obtained relatively accurately.

Is the gate valve flanged?

The most commonly used gate valves are threaded connections, flanged connections, and welded connections.Like the outer thread connection, the clamp connection, the card sleeve is seldom used.

What are the specifications of the gate valves? Does the work pressure need to be marked separately?

According to domestic valve model standards, the valve model is by the valve type, gate valve drive mode, gate valve connection, gate valve structure, sealing material, valve body material code to indicate.1, gate valve type code named Z;2, gate valve drive mode code by letters, common 2- electric hydraulic, 9- electric, 6- pneumatic, 5- bevel gear drive, 3- turbo worm; manual do not need to write out;3, gate valve connection form code with letters to indicate, 1- internal thread, 2- external thread, 4- flange type, 6- welding, 7- pairs clamp type, 9- clamp, 0- card sleeve;4, the valve structure of code, 0- flexible wedge, 1- rod single wedge gate valve, 2- rising stem wedge gate valve, 3- parallel single gate valve, 4- parallel double gate valve,

Is the gate valve clockwise or closed?

In general, the valve is clockwise turn off, in the case of special requirements under the opening.

Gate valve type Z40Y, Z40H letters - what does that mean?

According to the provisions of the JB/T 308-2004 valve type programming method:Z== gate valve4== connection: flange0== structure: wedge type elastic RAMY== sealing surface material: hard alloyH== sealing surface material: Cr13 stainless steel

Will the water supply and drainage to wear civil air defense gate valve, the use of bright rod or dark rod?

3, soft sealing rubber lining valve plate size uniform, interchangeable. Therefore, the soft sealing gate valve will be the direction of development, but also the water supply industry is willing to adopt a valve.