Q:What's the metal hose for fire fighting?

The main parts of production material is austenitic stainless steel hose, thus ensuring the heat resistance and excellent corrosion resistance of the hose, the hose working temperature range is very wide, is -196 - 600 degrees, use the hose on pipeline through corrosion for stainless steel plates, to ensure that the corrosion resistance of hose.

Q:What's the difference between a vulcanized rubber tube and an intake manifold?

Air intake pipe is the air from the air inlet, through the air filter, until the individual cylinder into the front of this section of the pipeline, is the main intake line of the engine, but also the total intake line.

Q:How can I remove all the flavor on the rubber hose?

After the hot water is directly boiled, wrap it directly with transparent glue

Q:How can the hose of natural gas be connected to the water heater?

Both ends of the hose nut with inlet joint head directly said water heater, the key is the nut inside with sealing ring can not forget the good, but also to the right, after tightening will not leak, then good with soap and water leak, do not bubble. But you must point out that the safety requirements can not be connected to the general hose, should be connected to the hard tube (Bai Tieguan), temporary answer, we must pay attention to safety.

Q:Rubber soft joint, what brand of good, the best price is more reasonable. Don't say anything expensive.

The rubber joints produced throughout the country have the longest history in Shanghai, and have the characteristics of the type and sales volume of Gongyi city. They have been sold in the plumbing market all over the country

Q:Why should the high pressure hydraulic tube peel off the outer skin?

Skinning requirement:The stripping length of hydraulic hose shall be two to four mm shorter than the caseA layer without peeling, more than two layers stripped to see the steel wire, otherwise the shell is easy to fall offThe size of the joints to be installed depends on the size of the joint and the quality of the hose, just start recording more to find the most suitable size.

Q:Carbon dioxide gas shielded welding torch wire feed hose joint, that steel wire can not be drawn out, how to solve it, with welding?

Replaceable welding wire feeding tube wire feeding tube can be directly removed, if not directly pull out, it may be the welding current and wire melting welding in together, there may be a wire feeding tube after the corrosion resistance increases to pull out, encountered such a situation like a gun only;

Q:Could you tell me the maximum pressure that the hose can bear?

It doesn't make any sense because there is no higher hydraulic pump that can work above 35MP. Of course, there is a super high-pressure hydraulic hose, the working pressure of up to 80MP., using 6 layers of steel wire or more winding process.

Q:The small hose attached to the grease gun is coarse or fine at the joint

The joint on the grease gun is made of fine thread. The characteristics of fine thread are small pitch, small spiral angle, good self-locking, and not easy to loosen.

Q:What about leakage of hose joint?

No matter what kind of pipe joint leaks, you can repair the hose with a special adhesive tape for temporary repairs. Specific operation method is: first, close the valve after the water is cut off, open the faucet to the appropriate position to release most of pressure inside the pipe and then use special tape tied Water Leakage parts, or with epoxy adhesive to seal.