Best Place To Buy Packing Tape

Hot Products

Factory Supply Light Steel Keel T-Bars Galvanized Ceiling T Grid Good Quality Galvanized

Cold Rolled Steel Galvanized Profiles Drywall C Channel steel sizes

construction building materials steel profile galvanized metal stud and track

Drywal steel profile/Good construction material

Drywall Profile-Track for Partition System

Drywall Profile-Stud for Partition System

Galvanized steel profiles U/C channel for drywall

Galvanized Metal Drywall Profile Stud Track Furring Channel 50*19*0.5mm

Galvanized stud for gypsum drywall metal stud and track

Galvanized Light Steel Keel Main Channel Drywall Partition Light Steel Keel

FAQ

Light steel keel cut off the keel and the ground with what fixed?

Playing a good line, with 25 steel nails directly to the keel to the ground fixed, If the ground is too hard nails do not enter, use hammer to play the cork now, and then in the fixed keel.

Light steel keel wall cheap or cheap red brick

Of course, is the light steel keel, probably in 70 a square, wall, then 12 of the wall art manual brick is 80, double-sided batch of 30, is 110!

Light steel keel wall in the end is how much money to know

The partition depends on whether you are single or double-sided single-sided 30 a square double-sided 50 a square called 70 are cut your gypsum board has 13 to 23 blocks have you do partition And not good gypsum board as long as 14 to 15 pieces of gypsum board on it

What is the decoration of the wall? Lightweight bricks Or light steel keel frame?

Well, I think so, I found two companies were quoted, the price is almost, but the listed materials are not the same.

How to install light steel keel gypsum board wall

In addition to the open slit, gypsum board wall vertical and horizontal joints (including gypsum board and between the gypsum board and the roof, side wall joints) must be caulked and paste the seam. Dark seam handler: (1) embedded in the putty: sweep the gap in the floating soil, with a small knife put the putty embedded in the seam and slit flat. (2) scraping the bottom of the putty: caulk putty final condensate, in the joints on the scraping about lmm thick putty and paste the glass fiber band, and then from the upper and lower sides of a knife from scratch, so that the excess putty from the band Mesh out of the hole. (3) scraping the middle of the putty: the bottom of the putty solidification and still in the wet, with a large knife putty putty, the glass ribbon buried in the putty layer, and the gypsum board wedge-shaped edge filled leveling. 8. Wall decoration Light steel keel gypsum board wall wall decoration practices, can be used to brush, paint, paint, paper or tile veneer.

Light steel keel with what screws fixed gypsum board

With fast wire. Fast wire: cone tip, countersunk head, cross marks, double wire with boiled or galvanized surface treatment. ?????? Fast wire that is fast teeth screws, usually usually belong to self-attack class.

Gypsum board wall is generally done to the height of the original roof or do the height of the ceiling?

First cut off, after the cut off does not matter. Fixed the problem to your decoration workers. No headache. The First cut off, after the ceiling so that when the ceiling of the wall at the top of the site good handling. Cut off the height of more than 3 meters a few centimeters on it.

Light steel keel wall Why do not cross brace welding with welding

Then the book is too much trouble to weld, to master the master to welding, Moreover, the time is too long, so no one with the welding.