100ah Lithium Battery

Hot Products

Best Price High Voltage 192v 380v 10kw 15kw 20kw Lithium ion Battery For Solar Energy Storage System

Stocked In Africa Wall Mounted 51.2v 100ah Lifepo4 Battery Powerwall

Low Voltage 2.5KWH 5KWH LiFePO4 Ultra Thin Wall-Mounted Home Energy Storage Battery

Powerone good quality all in one battery with IP65 and APP(JX)

Motive power battery 6V 200Ah AGM Deep Cycle Battery

Factory price stacked energy storage lithium ion battery 48v 100ah 5kwh 10kwh 20kwh

wall-mounted home solar storage lithium battery 51.2v100ah (JX)

14kwh spot inventory panama warehouse home lithium battery used for solar system

Factory price spot inventory 5.12kwh Household lithium Battery for Solar System

Spot Inventory 5.12kwh Panama Warehouse Home Lihtium Battery for Solar System

FAQ

The role of the battery?

It filled with lead plate filled with sponge lead as a negative electrode, filled with lead dioxide lead dioxide as a positive electrode, and with 22 to 28% dilute sulfuric acid as electrolyte. In the charge, the electrical energy into chemical energy, the discharge of chemical energy and into electrical energy.

80ah how much battery storage capacity?

Is 80AH. Understood to discharge at 80 amps for about 1 hour (but not to say that after 1 hour is finished, there is still electricity). In theory, this is your battery power.

How to determine the battery is good or bad?

If less than 9V but the pointer is in a certain value does not move that the battery is in a state of loss, need to add charge.

Lead-acid battery how to maintain?

After passing the test, cover the exhaust cutting, pay attention to restore the filler, cover the battery cover, if the cover is glued, then glue bonding.

What battery does the van use?

The most obvious feature of lead-acid batteries is the top of the plastic cover can be unscrewed, there are ventilation holes above. These fillers are used to fill pure water, check the electrolyte and the use of exhaust gas. In theory, lead-acid batteries need to check the density of each electrolyte and the level of liquid, if there is a need to add distilled water. But with the upgrading of battery manufacturing technology, lead-acid battery development for the lead-acid maintenance-free batteries and colloidal maintenance-free batteries, lead-acid batteries do not need to add electrolyte or distilled water. Mainly the use of positive electrode to produce oxygen can be absorbed in the negative oxygen cycle, to prevent water reduction. Lead-acid water batteries are mostly used in tractors, tricycles, car start, etc., and maintenance-free lead-acid battery wider range of applications, including uninterruptible power supply, electric vehicle power, electric bicycle batteries. Lead-acid batteries according to the application needs to be divided into constant current discharge (such as uninterruptible power supply) and instantaneous discharge (such as car to start the battery).

What are the hazards of battery over discharge?

The battery discharge to the standard termination voltage when the internal resistance will become larger, the battery electrolyte concentration will become very thin, especially the battery plate micropores and battery plate surface these two points are almost neutral; battery over discharge because of Internal resistance will become larger, so the battery will appear inside the phenomenon of heat, the battery volume will appear fever expansion.

What is a maintenanceable battery?

This is relative to a maintenance-free battery. Maintenance of the battery needs to be supplemented with electrolyte to ensure work, while maintenance-free is not required.

How should the battery be well maintained?

Electrolyte density This is to evaluate whether the battery charge is normal, whether the aging of the important parameters, the use of density meter or electrolyte density tester can be measured. If the electrolyte density is too small, you need to charge. And the electrolyte concentration is too thick or too thin to a certain extent, it means that such as the occurrence of plate vulcanization, short circuit or overcharge phenomenon, this time on the need for maintenance.