Sign Board Plywood

Hot Products

18mm Melamine Slotted Board without Aluminum

Melamine MDF Board Wood Grain Melamine MDF

4*8 feet Veneer Plywood/Commercial Plywood/Melamine Plywood 9mm 12mm 15mm 18mm

Melamine Slotted MDF Board for Furniture Making

Melamine Chipboard Melamine Particle Board for Furniture Making

Satin Surface Finish Melamine MDF Boards

Melamine Faced MDFBoards in Different Wood Grain Colors

Ash Wood Grain Embossed Surface Melamine MDF Board

18mm Melamine Slotted Board with Aluminum

Melamine Faced MDF Boards in Solid Colors

FAQ

Wall shape plywood with light bulb how much appropriate

10cm is enough on the one hand you have to look good to see too little slightly stingy too much easy to see inside the lamp

Wooden door surface panels (multi-layer board) is a solid wood door or solid wood composite door?

This is a typical composite door process. Some doors, especially in the middle of the door made of Chengdu directly wooden side, there is no MDF, and then paste the two sides of the decorative panels. Some boss said it was solid wood door.

What kind of glue when you use it?

General mud with less glue, mainly pre-decoration, it is reconciled with stone powder after leveling cracks, to the carpentry and paint workers with more glue.

What are the types of wood panel?

2. Maple: pattern was obvious water ripples, or was thin stripes. Milky white, elegant color uniformity, high hardness, high shrinkage rate, low strength. Used for solid wood flooring, as well as furniture trim panels.

What are the advantages of ecological boards and other boards?

Consumers in the selection of such plate furniture, in addition to taking into account the color and texture satisfaction, but also from several aspects to identify the appearance of quality: whether stains, scratches, indentation, porosity, color gloss is not uniform, there is no Bubbling phenomenon, with or without local paper tear or defect phenomenon and so on. If the phenomenon of veneering cracking or damage, you can use the following methods to repair: first in the damaged place to put a damp cloth, and then put a hot iron on the hot cloth, forcing the moisture into the veneer, so that the veneer becomes tough and difficult Fragmentation. So that you can first clean the old plastic, and then coated with a layer of milk at the grass layer of wood, and then in the loose surface of the negative coated with a layer of new plastic, compaction, to be completely dry glue.

How to choose melamine plywood

Melamine plywood because of its variety of colors and wear, durable, etc., more than the natural veneer color, color suit for each person, do computer desk table, stand and so on.

Melamine plywood and fire board panels which is good? That environmental protection?

Fire board veneer is three layers, relatively thick, and trimer polyamine plate veneer only one layer, relatively thin.

The good and the bad of wood is not determined by the severity

5, saw: the best conditions, then the board saw the saw, to see its internal quality, slat texture is dense, with or without obvious cracks and rotten rotten wood, decaying wood may exist in the incubation, the future prone to insects Borers, with or without large gaps.