Geotech Fabric

Hot Products

ECB Geomembrane

Reinforced Geomembrane

Long Fiber Nonwoven Geotextile

LDPE Geomembrane

LLDPE Geomembrane

Reinforced Geomembrane

Polyester PET Filament Nonwoven Geotextile

LDPE Nonwoven Geomembrane

Staple Fiber Nonwoven Geotextile good burying

PET Long Filament Nonwoven Geotextile

FAQ

Why calculate the amount of time to count a lot of cushion ah

In the building construction refers to the base is located below the cushion sometimes also served as grassroots. With the cushion, in the above work is convenient, clean, especially the mold, bar reinforced, pouring concrete and other processes, will not be affected by the basic earth pollution. Set the place where the cushion is generally based, floor, roof (slope) and so on.

What is the waterproof layer and the waterproof cushion in the tile roof?

In the tile roof, to wait for the waterproof layer after the dry layer, or prone to the phenomenon of wall off. Waterproof layer set and standard construction methods: to be painted 2 to 3 times, or should be added fiberglass cloth, and each brushing the thickness of the cured material shall not be less than 1 mm, and should be completely dry (about 5-8 Hour) and then the next construction. After brushing, but also in the paint waterproof layer to do a mortar protective layer, and finally paste the tile.

How to build a fine stone concrete cushion?

Reduce ground cracking, plus steel mesh. Reinforced mesh, should be placed in the middle of the concrete, because the protective layer of concrete thick Fang generally only 5CM thickness, so the middle is the best.

Basement floor mattress dry to what degree can do coil waterproof?

Pull a square coil, tiled on the floor above, in the case of the sun, the sun shines on half an hour, in turn, look at the coil, if no water to prove that the water content is not large, that can be construction.

Basement cushion waterproof

Fourth, improve the waterproof performance: 1, Aggregate graded concrete, is the use of different aggregates of the aggregate and improve the content of cement mortar in the concrete, so that the mortar is filled between the aggregate, thus blocking the aggregate is not dense between the seepage channel , Improve water resistance; 2, plus concrete, is added in the concrete air conditioner or dense agent to improve the impermeability.

Is foam concrete suitable for use as a cushion?

The foamed concrete is a foaming system through a foaming machine that allows the foaming agent to be fully mechanically foamed and the foam is mixed evenly with the slurry.

Cushion, waterproof layer construction to do what information

2, bedding (bed course) refers to the structure below the grass-roots level. Its main role is to water, drainage, antifreeze to improve the grass-roots and soil-based working conditions, the water stability requirements are better. The cushion layer is a structural layer between the base layer and the soil base. When the soil quality is poor, it is used to improve the water stability of the soil base, improve the water stability and frost resistance of the pavement structure and disperse Load to reduce soil deformation.

When the cushion is used, the thickness of the protective layer is not less than ()

Not on the roof: the general waterproof layer above can be used 15 ~ 25mm cement mortar protection.